I have a 1990 Jeep wrangler with throttle body injection -found the computer hanging above the glove box- there are four nuts that hold the hold on bar and glove box. Then go to the fire wall to the right side of the battery box and the internal bracket is held there by two nuts to the fire wall. The computer can then slide out, be unplugged and exchanged.
On a 1990 Jeep Wrangler, the IAT sensor is located on the intake manifold. It is a gray, two-wire system situated on the front of the manifold.
Inside the fuel tank
How do you change the steering shaft in a 1990 Jeep Wrangler?
The amount of oil needed for a 1990 Jeep Wrangler is 6 quarts. The Jeep Wrangler uses 10W 30 oil.
I shouldn't, 1990 is a YJ and the 97 is a TJ.
You want to look on the intake manifold on the Jeep Wrangler.
Top driver side of the bell housing.
The engine computer is the voltage regulator.
Certainly, they are both YJ"s.
Yes, it will fit just fine.
A 1998 Jeep Wrangler does not have EGR.
what is the switch located in the battery tray on a 98 jeep wrangler
Where is the resistor on 2001 jeep wrangler
A 1990 Wrangler would be a YJ.
The engine computer is also the voltage regulator.
where is the oxygen senor located on 1995 jeep wrangler
A 1990 Jeep Wrangler needs approximately 6 quarts of oil for an oil change.
A computer from a 1992 Wrangler with the same engine is what is compatible.
it is located to the right side of the gas pedal up under the dash
The engine computer is also the voltage regulator. It is located behind the battery.
Jeep does not use inertia switches. The fuel system is computer controlled with relays.