0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the bleeder valve on 2003 Ford Escape?
Brake bleeder? Clutch bleeder? Coolant bleeder?
Does a 2003 KIA have a bleeder valve on the coolant system?
yes it does
Where is the coolant bleeder valve on a 1999 Pontiac Grand Am?
The coolant bleeder valve should be on the front passenger side of the engine. It will be on one of the metal hoses. The bleeder valve on the 3400 V6 engine is located on a black stem where the water pump connects to the engine block.
How do you add coolant to a 2003 Pontiac Grand Am?
Adding coolant to a 2003 Pontiac Grand Am is very easy to do. The coolant can be directly added to the radiator. Make sure the engine is not hot before adding the coolant.
Where is the coolant bleeder on a 1996 grand am?
Lower corner rad, driver side. Looks like a plastic key.
Where is coolant drain on 2003 grand am?
The coolant drain on a 2003 Pontiac Grand Am is located on the bottom of the radiator on the right side. It allows coolant to be quickly removed during maintenance and flushes.
Where is the air bleed valve for the cooling system on a 2003 Nissan Maxima?
Where is the coolant bleeder valve located on a 2003 nissan maxima 3.5
Location of coolant temperature sensor on a 2003 Mercury Grand Marquis?
Location of coolant temperature sensor on a 2003 Mercury Grand Marquis?Read more: Location_of_coolant_temperature_sensor_on_a_2003_Mercury_Grand_Marquis
Location of coolant bleeder screws 2003 dodge 5.7?
its on the driverside of radiator. Near the bottom. just a plastic pipcock.
What type of coolant do you use for a 2003 Pontiac grand am?
Thank you for the answer
Does a 2004 Chevy avalanche have a coolant bleeder valve?
Not sure but, if it does have a bleeder it would be located at the highest point where the coolant flows in the engine.
How do you bleed air from the cooling system of a Pontiac Grand Am?
It should be a bleeder screw connected to the cooling system, it might be two.If you find it,you should open one at a time.Pour coolant into the system slowly,until coolant start coming out of the bleeder screw and then close it . DO it to the second screw too.Now if you do not have the bleeder screws.Pour coolant into your system slowly and squeeze the top hose until no bubbles come out and the coolant level should go down at this time and then pour alittle more in there
