Want this question answered?
It is mounted to the lower intake manifold just below the thermostat housing. It has a connector with two wired connected to it.
Coolant Recovery Reservoir. There is no sensor in the coolant recovery tank on a 1998 Buick Regal.
The body temp is 38-38.2 Celsius
5w-30 outdoor temp. from & below 0 F (-18 C) to 100 F (38 C) 10w-30 outdoor temp. from 0 F (-18 C) to 100 F (38 C) & above temp.
If the sensor is blocked or has mud on it, the readings will be inaccurate, and give completely false readings.
Higher than humans, about 38 degrees Celsius, or 100.4 F (Fahrenheit).
Well 37.5 is the "norm" so anything over 38 (especially in a child). If it ever hits 40 I'd get to the hospital. You can also have a temp if it drops under the norm too.
On top of the cam sensor synchronizer which is sticking out of the top of the timing cover on the front of the engine.
There are two parts to this. the Temp sensor is just under the air intake. one clip that has two wires on it. You will need a deep well socket. I think a 3/4 will do it. You might have to remove the air breather to see it as it's very deep under the air intake. Now there is also a "temp switch" it's about at the same height as the sensor on the motor but it's on the fire wall side. It uses the same wire harness so just follow that as it's the second thing in line to the sensor. It has only one wire going to it. I replaced the sensor and the gauge didn't do anything. Then I got the "switch" and it's all ok now. each part was 20 bucks at auto zone. Easy to fix.
It's a thread in style IAT sensor , so it has to be threaded into the upper intake manifold somewhere
0.63 hr = 38.18 min = 38 min and 11 sec.
the ideal temp for concrete placement is 15-25* C if the temp is above 40*C concrete requires cooling and if it is below 5*C it requires heating. FINDINGS 1> 25mm slump decrease for each *C increase in temp 2> If the temp is 38* C and the humidity is 25% than concrete strength after 28 days can be reduced to 62% as compared to strength if the temp during concreting were 23* C with 90% Humidity !