0
Call autozone and they will have a diagram of where this is. also in the haynes manuel the is a location showed for you
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the crank position sensor in a 1995 olds delta 88?
on a 1994 it's behind the harmonic balancer
Where do you replace the Crank Position Sensor in a 1993 Oldsmobile 88 Royale?
on the front of the motor under the front crank it has a plug going to the crank.
Where is the crank angle sensor located on the 88 GL hatchback?
It is integrated in the distributor.
Why won't my 1986 fiero strart?
my 88 fiero had two valves stuck, one on cyl 2 and one on cyl 3.. if it would start it was on one or two cyl... or he crank senor might be bad
What would make a Jeep Comanche pick up not have ant fire to the plugs?
My problem on the 88 I was working on turned out to be the crank position sensor located on the driver side top of the bell housing.
How to locate a cam position sensor for a 88 trooper?
it's built into the distributor
What can i do to get a 88 Oldmobile cutlass supreme to start i just had the coil packs changed what else could it be?
Check the crank sensor
1998 Oldsmobile 88. has no spark replace the igniton control module. what else could it be?
crank or cam sensor...did you already figure it out?
What would cause a 98'Olds 88 to not start 3 mechanics can't fix it?
depending on what year I have researched and found my 94 olds 88 has a gm commonly failing part called a Crank Shaft position sensor it is located behind the tensioner pully cost me $200 to have it tested and replaced and I haven't had a problem since
Where is a crankshaft sensor on 88 celebrity?
The location of the crankshaft position sensor depends on which engine the car has. If it is the 2.5L 4 cylinder engine the crankshaft position sensor is behind the ignition module. If it is the 2.8L V6 engine the crankshaft position sensor is on the side of the engine nearest the firewall and just above the pan rail in about the center of the block.
What causes 88 Corsica to backfire and not start?
there is a few things that could be wrong, its very possible that the timing chain is shot or the crank positioning sensor is bad
What is the setting for a crank prosion sensor on a 1990 olds 88 3800?
The setting is you better have good eyesight! It has to be positioned between the fins on the back of the cranshaft dampner.
