answersLogoWhite
Dodge Ram
GMC Sierra
Crankshaft Sensors

Where is the crank sensor located on a 2000 Dodge pickup with a 5.2 liter engine?

434445

Top Answer
User Avatar
Wiki User
2005-12-10 01:27:43
2005-12-10 01:27:43

on the passenger side of the engine by the head and the bellhousing of the transmission you will need a 13 or 14 mm socket to remove and unplug the wire over by the distributor

1

Related Questions

User Avatar

its located right on the top of the motor by the compreesor

User Avatar

Just to the side of the thermostat housing.

User Avatar

The oil pressure sensor is located on the back of the engine, next to the distributor.The oil pressure sensor is located on the back of the engine, next to the distributor.

User Avatar

where is the crankshaft sensor on a 1994 dodge pickup with a 5.9l engine?

User Avatar

where is the engine speed sensor located on a 1999 dodge stratus 2.4 l

User Avatar

The speedometer signal comes form the abs sensor on top of the rear axle.

User Avatar

The 2006 Dodge charger knock sensor is located on the back of the engine. The knock sensor will be near the bottom of the engine cover.

User Avatar

The oil pressure sensor on a gas engine is on the back of the block next to the distributor.The oil pressure sensor on a gas engine is on the back of the block next to the distributor.

User Avatar

If, by ECU you mean "Engine Control Unit", I don't believe a 1968 dodge pickup had one.

User Avatar

It is the "pick-up" plate in the distributor.

User Avatar

Where is the MAF sensor located on a 2000 Dodge Ram 1500

User Avatar

AN engine that will not run correctly if at all.

User Avatar

the cam sensor is under the distributor cap.this engine uses the distributor pickup as a cam reference since the dstributor is cam driven

User Avatar

The speed signal comes from the abs sensor on top of the rear axle.

User Avatar

The vehicle speed signal comes from the ABS sensor on top of the rear axle.

User Avatar

The camshaft sensor is located on the drivers side top of engine at the end of the valve cover.

User Avatar

The cam sensor is on the driver side of the cylinder head.

User Avatar

If you remove the intake housing, and look at the carburetor from straight on, it is right there.

User Avatar

It is located inside the distributor. I dont know of any one that sells it seperately

User Avatar

For a gas engine the pump is in the fuel tank.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.