0
the unit bolted to the left of the front cam housing ....
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the crankshaft sensor located in a rover 200?
The crankshaft sensor on a Rover 200 is located below and to the right of the generator and cylinder head temperature sensor. It is on the driver's side of the engine and above the oil filter.
What do i check on 1985 grand marquis if turns over but wont start have power to coil but no spark?
i am a land rover master tech,the first thing to do is make shure you have a good battery.test the fuel pressure and if there is no fuel pressure the fuel pump will take out the crank sensor leavig vehicle with no spark. so if you have good fuel pressure and no spark it sound like your crank sensor is bad.common problem. i hope i was able to help you.
Correct engine mount measurements to put a land rover discovery 300TDi engine in to a land rover defender V8 chassis?
yes
What interval to you replace a timing belt on a Rover 600?
Well, if its a petrol engine, i assume its the same as the Honda accord made between 1994-1998, because they really are the same car.That interval is 60000miles.
What would cause a Rover 75 to lose voltage to injectors resulting in nonstarting?
If there is no 12v positive feed then its either a fuse or wiring, the computer works the injectors by switching the earth so if the pos is there but no injection then it might be ECU. However the ECU is signaled by the crank position sensor. Easy was to diagnose this is if there is no spark or negative switch from ECU.The common denominator is the crank sensor located down the back of the block near the bell housing.There are so many silly things that can cause this, i would NOT run out and but a computer. Check injection fuse in the fuse box in the engine bay for starters. Hope this helps. Post more questions and il try and help.
Where is the location of crank sensor for range rover v8 4.6HSE MODEL 1999?
The 1999 Range Rover 4.6 liter engine crank shaft sensor is located on the back of the engine. The crank shaft sensor is behind the rear engine cover.
Is it a Honda engine in rover 25 car?
onda engine was in the rover 25
Where is the crank sensor for range rover v8 4.6HSE MODEL 1999?
Opposite side of the engine that the starter is located on, same height as the starter
Where do if find the crank positioning sensor for a 2000 land rover discovery?
They sell them at Autozone for about $160.00 www.autozone.com
How to replace a 2002 land rover discovery crank shaft sensor?
"http://wiki.answers.com/Q/How_to_replace_a_2002_land_rover_discovery_crank_shaft_sensor"
Where is the crankshaft sensor located in a rover 200?
The crankshaft sensor on a Rover 200 is located below and to the right of the generator and cylinder head temperature sensor. It is on the driver's side of the engine and above the oil filter.
Why does my Rover k series Engine not start when hot?
engine coolent temperature sensor is giving incorrect readings when warm
Where is the speed sensor on rover 200?
where is the speed sensor on a rover 200
Where is the cam sensor on a 1996 Land Rover Discovery?
at the front of the engine beneather the camshaft pulling
Where is the intake air temperature sensor on a 2002 land rover freelander?
The intake air temperature sensor is under the intake manifold on the 2002 Land Rover Freelander. It is on the top rear section of the engine.
On an 1986 range rover 3.5l v8 efi where does the crank signal come from?
i dont understand your question. but if you want to know if there is a crank sensor or something the anwer is no. since your car is an old model and it has distrubutor.
Rover coupe with a broken k series engine can you replace this problem engine with the Honda engine or any other engine?
Probably not, you would need a new `K` Series engine as the internals for the engine will be in different places. Honda didnt just put an engine in the rover they also wired the entire car. The engine bays are both totally different. If you still wanted to do this a conversion would need to be done.
