answersLogoWhite

0


Best Answer

On a '97 prizm with a 1.6 L , it is on the back (cabin side) of the engine near the belts, just above and aiming down at the crankshaft. The lower belt pulley is mounted on the end of the crankshaft. The wires connect higher up near the valve cover. ( 2 wires , connecter is right above it about 6 inches up)

97 prizm 1.6 L automatic transmission w a/c

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the crankshaft position sensor located on a geo prizm?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why would a geo prizm not have spark engine Turns but does not start replaced entire distributor 3 times already all components are located inside arent they Crankshaft position sensor?

the cam position sensor and ignition coil are inside the distributor. the crank position sensor is located on the bottom front of the engine, behind the belts on the left side.


Is a 97 Toyota corolla and a 94 95 geo prizm engine interchangeable?

96 and 97 Corolla and Prizm are the same, but, they have an extra crankshaft sensor, that the 93, 94, and 95 does not have,


Where are sensor wires located in 92 geo prizm?

There are many sensors in that vehicle. We need to know which sensor.


Where is the speed sensor located on a 91 geo prizm?

i have a 1996 Mazda protege and it is at the rear of the transmission if you're looking from the front drivers side. it is almost directly under the throttle position sensor which is located on the rear of your throttle body close to the firewall (almost directly in the center of the engine compartment).


Where is the vacuum diagram located on 1990 Geo Prizm?

where is the vacuum diagram located on 1995 geo prizm


Where is the IAT sensor located on a 1991 geo prizm?

The intake air temperature sensor on a Geo Prism would be a part of the air intake system. More specifically, it would be on the engine side of the air cleaner housing.


Where is the speed sensor located on a 93 geo prizm?

if you get under the hood on the drivers side, lean in a little bit, look down the firewall, you will see it sitting on your transmission.


Where is the heater control valve located on a 1998 prizm?

Locating on a 1998 prizm - fine idea


How do you replace coolant sensor in a 2001 Chevy prism?

Type your answer here... where is the coolant sensor ona 2001 chevy prizm


Where is the oil pressure switch on a 1994 GEO Prizm?

where is located the oil pressure switch for 94 geo prizm


Where is the fuel pump relay on a 1996 geo prizm?

where is located the fuel pump relay on 1996 geo prizm


Where is the coolant temperature sensor located on a 1999 Chevy Prizm give me an answer at kinselok06atyahoo.com Thanks?

on the back of the engine where the plug wires plug into the coil it is under the coils i had to remove the coils to get to it hard but can be done