It is located under the starter. I had to remove the fan shroud to access the sensor's one 10mm bolt. It was an exceptional headache on my car because I had hit a deer and the insurance company replaced my radiator with a low cost, non OEM radiator and it did not have a removable upper goose neck. This necessitates removing the radiator to be able to remove the fan shroud.
The 1994 Volvo 850 crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
Where is the crankshaft sensor located on a Chevy 1500 sil. turbo diesel truck?
The tach signal comes out of the pcm. The pcm watches the crankshaft position sensor to calculate engine speed. The crankshaft position sensor is behind the starter.
It is the three wire sensor on the driver side end of the cylinder head.
Top driver side of the bell housing.
were is the camshaft position sensor on 1999 Volvo s80 turbo
the camshaft position sensor on an 04 pt is located on the right side of the engine, towards the top (looking at it from the front), directly in back behind the oil dipstick on a non-turbo
It does not have a crank case sensor.It does not have a crank case sensor.
In my '97 Eclipse GST (the convertible model of your car), the Crankshaft Position Sensor, or Crankshaft Angle Sensor, is located behind the crankshaft pulley. To get to it, the Mitsubishi shop manual lists the removal of the timing belt. Not a fun job. Since the timing belt will be removed anyways, this is a good time to install a new belt. The Mitsubishi dealership also suggested replacing the timing belt tensioner when re-installing the timing belt.
On a 94 Turbo DSM there is no crank angle sensor. The Cam Angle Sensor(CAS)serves the function of both a crank and cam sensor, and it's located on the passenger side of the valve cover at the end of the intake camshaft, you can't miss it.
on the timing cover sensing the damper
Yes there is... It's behind the head and connects to the top of the bell housing.... 10mm socket will be needed.... DON"T DROP THAT BOLT INTO THE HOUSING ONCE THE SENSOR IS PULED OUT..... Make sure the cable has a white stripe on it...