answersLogoWhite
Saturn L-Series
Crankshaft Sensors

Where is the crankshaft position sensor on a 2000 Saturn LS-2 V-6 located?

424344

Top Answer
User Avatar
Wiki User
2008-04-12 19:27:39
2008-04-12 19:27:39

I'm experiencing problems with my Saturn also so I was checking to see if anyone else is having cranking and cutting off problems. Check this out. Hope it helps let me know. I called the Saturn dealership and they said it was either the fuel pump or the crankshaft position sensor. I had the fuel pump checked earlier; it was ok. ...

www.automotiveforums.com/vbulletin/t237239.html RobE ------------------------------------------------------------------------------ My 2001 Saturn L300 had random problems starting hot, cutting off intermittently and erratic transmission shifting. No check engine light. Multiple posts on different sites indicated the CPS as the cause. Purchased sensor from Saturn dealer for ~$100 and installed. Installation very simple. Sensor is located just under the oil filter housing on the front of the engine block. Very accessible from front of car without jacking or ramps. Sensor is held in by 1 male torx screw. Good luck!

1

Related Questions

User Avatar

were is crankshaft sensor located in 2001 Saturn l300

User Avatar

its located next to a few nuts and blots

User Avatar

where is crankshaft position sensor and camshaft position sensor on a 2004 Jetta 2.0 gl

User Avatar

http://www.youtube.com/watch?v=PVTFFOwqNZM richpin

User Avatar

how to replace the crankshaft position sensor located in a 2003 kia rio

User Avatar

Where is the crankshaft position sensor located on Audi 2002 Audi TT

User Avatar

The 2003 Saturn L200 has a camshaft position sensor. It is located on the bottom front of engine behind the Starter. You will need to remove the two bolts that are holding the Starter to get to the sensor.

User Avatar

The crankshaft position sensor is located on the front of the engine. It is just to the left of the crankshaft pulley.

User Avatar

The sensor in the distributor is the crankshaft position sensor.

User Avatar

The crankshaft position sensor is located behind the timing cover and above the crankshaft gear. the timing belt my have to be removed to access the bolts on the sensor.

User Avatar

The crankshaft position sensor, on your 1992 Buick regal 3.1 liter, is located on the back of the engine. The crankshaft position sensor is on the inside of the engine cover.

User Avatar

The 1995 Mitsubishi Eclipse crankshaft position sensor is located on the back of the engine. The crankshaft position sensor will be near the bottom of the engine cover.

User Avatar

The 1998 Saturn SL2 will show a code 340 and 341 for a camshaft position sensor because this part is also considered the crankshaft position sensor on the Saturn. The location of the crankshaft position sensor is behind the alternator on a 1998 Saturn SL2. Both crankshaft and camshaft are the same thing This vehicle is not equipped with a camshaft position sensor. Saturn is the only manufacture that uses a auto pulse generated inside the ignition control module in conjunction with the pulse received from the crankshaft position sensor to determine ignition and injection timing. If you have a code for camshaft position sensor the issue is with the pulse generator in the ignition control module.

User Avatar

On my 1995 Mercedes Benz E320 where is located the crankshaft position sensor?

User Avatar

It's located on the front of the engine block by the oil filter.

User Avatar

The rear crankshaft sensor is located on the back of the crankshaft. The rear engine cover will need to be removed in order for the sensor to be visible.

User Avatar

The crankshaft position sensor on a Buick is located behind th Harmic balancer. It should have a wire plugged in to it.

User Avatar

The sensor is located directly above the crankshaft pulley. The camshaft sensor also connects with the crankshaft position sensor.

User Avatar

The crankshaft position sensor is located at the lower left hand side of the crankshaft pulley. The crankshaft pulley is the large pulley located in the center lower portion of the front of the engine.

User Avatar

Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt

User Avatar

The crankshaft position sensor on a 2005 dodge grand caravan is located on the top side of the bell housing.

User Avatar

next to the oil filter. (side of engine, front of car)

User Avatar

The crankshaft position sensor is located on the front side of the engine block near the flywheel/driveplate

User Avatar

it is located on the side of the transmission


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.