Want this question answered?
The only thing I can think of is to glue the button in the door jamb.
I called any dealership parts department and not only will they provide a picture they also provide instructions...
look on the inside of your drivers side door it will tell ya if not repost the question and ill check mine
The chime may ring on a 2000 Mazda MVP if a door is open and the keys are not in the ignition because the car has a secondary alarm system that is letting the driver know that a door is ajar. If the door is opened while someone is sitting in the passenger seat it might go off before the person exits the vehicle.
It is in the door latch. You need to replace those switches. There are two in the drivers door and one in the passengers door. Take the door panels off and remove door latch and replace swithes.
Push the Trunk button on the driver door.
Locate the door chime...Locate the 1 bolt that holds the door chime. Pull down the chime.Use a flat screwdriver to release the clip that holds the casing and the plug-in.Remove the plug-in .Now the door chime will not bother you anymore :)
You should be able to find a little rubber covered button somewhere on the door frame - you should be able to pull this out and disconnect the wires that go into the little button.
driver door panel........near bottom i know awkward place.
if it is just the door that is pissing you off, i solved the issue just by shoving half of a small (Bradly) nail into the door button to the button closed, no ugly tape and no the smaller part still sticks out a little so the light should still get the on n off signal while the stupid key chime no longer exist.
1. Begin with the driver's door open. 2. Within 20 seconds insert the key in the ignition , 3 times, turn the ignition key to the run / on position, then back to off. slide the key out of the ignition until the door open chime stops sounding , Press the open door button 3 times located on the car frame. 3. You should hear a chime indicating the car is in programming mode. 4. You can now program exactly 3 fobs. To do this, press any one key on each fob twice, waiting for an acknowledgement chime between each fob. If you have only one fob, do it 3 times. If you have 2 fobs, program the first one once, and the second one twice. 5. Press the door open button once. The car should chime.
Chime