There probably isn't one. Most U.S. cars require you to drop the transmission pan to drain the fluid, which you'd need to do to change the filter anyway. Just get the biggest pan you can find and resign yourself to taking a Transmission Fluid bath.
2005 Sienna oil drain plug torque-45 N-m or 33 ft-lbf
33 foot pounds
33 ft-lbs
1997 HONDA PRELUDE 2.2L 4-cyl VIN Code H22A4 TORQUES Oil Drain Plug.....33 ft-lbs Manual Transmission Fill Plug.....33 ft-lbs Drain Plug.....29 ft-lbs
My 2004 V6 is 12mm. Torques to 33 ft.lbs. Use new aluminum gasket to assure leak free operation.
buy new oil filter, oil, and a new drain plug and gasket. the used plug is prone to leakage. remove drain plug and drain in a big enough pan for all the oil. oil filter is located on rear of engine. easier to remove from the bottom of the car. put oil on the seal of the new filter and hand tighten. replace oil plug with new gasket and plug and tighten to 33 foot pound. add oil that is required and start car. when oil light goes out shut car off and check oil add oil as needed.
2008 Sienna Oil Drain PlugLook near the passenger side at the back of the lowest part of the engine... The oil plug is on the passenger side of the vehicle and uses a 14mm bolt. The filter for the car can be accessed either below the car or above. This, however, can be awkward to turn by hand - having a strap wrench makes getting to the filter a cinch. The torque for the plug is 28ft lbs. If you are looking at a plug with a hex or Allen type fitting, leave it alone as it is the transmission drain and many people have mistaken it for the engine oil drain. What To Do/How-ToSet parking brake while parked on a level surface and block the rear tires for good measure. Put spent oil tray underneath the drain plug and use a 14mm crescent wrench to loosen the drain plug. Direct the waste oil to the waste oil tray and the oil will be drained in about 10 minutes. After the oil has drained out, wipe off any oil on the casing with a clean cloth, replace the drain plug and tighten 28ft lbs to 33 - what is called for, but just get it good and snug if you do not have a torque wrench.
should be 33 mm
CAPACITIESEngine, without filter..........3.7 quarts[1]Cooling System, W/ AT Initial Fill..........7.4 quartsCooling System, W/ MT Initial Fill..........6.9 quartsAutomatic Transmission, Initial Fill..........2.5 quarts[2]Automatic Transmission, Total Fill..........6.4 quartsManual Transmission, ..........4.0 pints1. Add extra oil when replacing filter. Refill check oil level.2. With the ENG at operating TEMP, shift TRANS through all gears. Turn ENG off and check fluid level within one minute. Add fluid as neededTORQUESOil Drain Plug.....33 ft-lbsManual TransmissionFill Plug.....51 ft-lbsDrain Plug.....29 ft-lbsManual Transmission 20 x 1.5mm PlugFill Plug.....33 ft-lbsDrain Plug.....33 ft-lbsHope This Helps
CAPACITIESEngine, without filter..........4.2 quarts[1]Cooling System, W/ MT Initial Fill..........12.0 quartsCooling System, W/ AT Initial Fill..........12.0 quartsAutomatic Transmission, Total Fill..........9.1 quartsManual Transmission, W/ BW T5..........4.4 pintsManual Transmission, W/O BW T5..........6.3 pintsDifferential, Front..........2.7 pintsDifferential, Rear..........3.8 pintsTransfer Case,..........3.2 pintsFilters:Wix Oil Filter.........#_51334Wix Air Filter.........#_46006Wix Trans Filter.....#_58876Wix Fuel Filter.......#_33310TORQUESOil Drain Plug.....58 ft-lbsOil Drain Plug.....33 ft-lbsManual Transmission 2WDFill Plug.....22-36 ft-lbsDrain Plug.....22-36 ft-lbsManual Transmission 4WDFill Plug.....29 ft-lbsDrain Plug.....29 ft-lbsThis Should Help.
CAPACITIESEngine, with Wix Oil Filter # 51334..........4.0 quarts[1]Cooling System, W/ AT Initial Fill..........7.4 quartsAutomatic Transmission, Initial Fill..........2.5 quarts[2]Automatic Transmission, Total Fill..........6.4 quartsManual Transmission, ..........4.0 pints1. After refill check oil level.2. With the ENG at operating TEMP, shift TRANSthrough all gears. Turn ENG off and check fluid levelwithin one minute. Add fluid as neededTORQUESOil Drain Plug.....33 ft-lbsManual TransmissionFill Plug.....33 ft-lbsDrain Plug.....29 ft-lbsHope This Helps.
A (1/2)bh (b is base, h is height, A is area.)Plug in the numbers you know:99 = (1/2)(33)hSimplify:99 = (33/2)hDivide both sides by 33/2:6 = hThe height is 6 feet.