Want this question answered?
There is a large bolt on the bottom of the crankcase, underneath the brake.....that is your drain plug.
Not typically as they are a 2 stroke motor
The oil in a polaris trail boss 250 cc can be changed by first opening the hood of the car and figuring out where the oil valve is located. Remove the cover and then use a siphon to remove the bad oil. Then simply funnel in the new oil.
The crankcase drain plug on a 2007 Polaris scrambler 500 is hard to locate. However, it is behind the bolt in the skid plate.
Its right in front of the starter its a 10mm bolt with a phillips if it has coolant coiming out there replace ur water pump shaft seal. should be 10w30 and fill is in the front hard to get to coming up at an angle half way down the motor fill til it runs out u will need a bendable funnel.
It will depend upon whether you mean the engine oil drain or the Primary/Transmission oil drain. The oil drain for the engine oil is actually NOT a plug. Underneath the engine is a hose that is clamped to a boss on the frame. Loosening the worm clamp and pulling the hose off the boss will cause the oil to dump (you did put the drain pan under there, didn't you?)
You will need to remove the oil pan plug. Allow the old oil to drain out. Replace the oil pan plug and fill with new oil.
Hi You first locate the oil resivour. In the bottom right hand corner is the drain plug unscrew that and let the oil drain. Replace the plug and fill with oil. Be sure to also replace the oil filter
Transmission drain plug 2011 drain plug
spark plug gap for polaris 425
The oil drain plug right above the rock guard and is a 14 mm nut, hope this hepls a little
where is the plug on the 400 4x4 ATV to drain the oil? Isn't the 400 a two stroke? No oil in case.