0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Do all 1994 Ford Ranger 40 have an EGR Valve?
yes 2002 and later 30L are the only ones not equipped with an egr valve
Where is the E G R valve located on a 1994 ranger 40?
its at the right rear corner of the intake manifold
Where is the egr valve located on a 1994 ford aerostar?
I have repaired my vehicles for over 40 years, the engineers at ford have finally hidden a part from me, I have been looking for 3 weeks I cant find the EGR VALVE on the 94 3.0 liter aerostar.
Where is the EGR valve located on a 1993 ford areostar van with a 40 engine?
I have a 93 4.0 and it has no EGR valve. My neighbor who is a ford mech. says some don't have EGR's and some have only one O2 sensor.
What is it when a 95 Chevy Corsica surges when you accelerate between 30 mph and 40 mph?
the egr valve is sticking open and causing the motor to surge replace the egr valve and the problem will be solved
How do you fix a 1994 Ford Thunderbird that will not go over 40 mph?
BUY A CHEBBY??? LOL either your clutch is slipping or the transmission is slipping. IF it is an auto, check the fluid. could be a clogged catalytic converter clogged fuel filter/pump? I had the same problem with my 94 Thunderbird LX 4.6L(V8). You are going to need to replace your EGR valve. The EGR valve is blocked therefore the car cannot breath. The EGR valve price is pretty fair, if you go to an auto parts store. The valve ran me about $40. Now if you are going to put it on yourself you need 24 or 26 in. wenrch to get around the pipe it is counnected to.
Where is the EGR valve on a 2004 Mazda Mpv?
How replace the EGR valve on a 2004 Mazda MPV? I have been trying to replace the EGR valve of a 2004 Mazda MPV and I have not been able to loosen the nut. The nut is located in the rear side of the valve whish but is extremely stuck and I have been using different tools without any success, it won't even loosen just a bit, even using W-40. Can somebody help me with this case as soon as possible, or a way to clean it without having to replaced it or take it out.
Where is the egr valve located on a 2001 Mercury Cougar?
the egr valve is located on the intake manifold- next to the throttle cable. it looks like a ufo, has one wire coming out of the center. go to autozone ask to see the replacement and you will have no problem finding it. It cost $40 at auto zone . make sure you get the gasket w it.
Where is the ignition module located on a 1994 ford ranger with a 40 liter?
its mounted under the hood on the driver side fender
Why would a 1994 Ford Escort stall after 40 seconds at idle?
Some of the reasons your Escort would stall after 40 seconds at idle are: 1. Vacuum leak. 2. Plugged fuel filter. 3. Leaking EGR. 4. Plugged PCV valve 5. Air filter clogged. 6. Fuel pump below capacity. 7. Leaking head gasket. 8. Camshaft lobes worn 9. Idle Air Control (IAC) valve.
1994 ford ranger 4 0l xlt 5 speed manual trans when you start engine it has an adnormally high idle and takes 30-40 seconds to idle down and then when you hit the gas it does the same thing again?
Sounds like the Idle Air Control valve.
How do you test for if an EGR valve needs replacing on a Taurus - Sable?
Testing steps: * Remove the vacuum hose on the top of the EGR valve and plug it.* Connect a short hose to the EGR valve.* Start the car.* Now suck on the hose, or use an appropriate tool to apply suction to the line * this will open the EGR valve the engine should stumble and try to die.If it does the EGR valve is working. There is an "Exhaust gas manifold pressure sensor" that measures the exhaust gas flow to the EGR valve. The problem is the sensor itself becomes clogged with exhaust carbon and gives the computer a fixed false reading, the computer in turn sends too much vacuum to the EGR valve and the engine runs rough, surges and may die.This sensor on the 3.0 cast iron engine ( overhead valve no overhead cam ) is located by the firewall on or near the intake manifold and is connected to an exhaust tube running to the EGR valve by 2 short rubber hoses and has a 3 pin connector.The hoses measure pressure drop across a restriction inside the tube as exhaust gas flows through it to the EGR valve.I've replaced the sensor on 2 different Taurus', my wife's 99 and my sons 2002, the cars run great afterwards and the light goes off.About 40 bucks do it yourself easily. Twist the old sensor to loosen the hoses. Push the new sensor onto the hoses. The other engines should have a similar sensor somewhere.
