Location is under hood, driver's side, below and to the left of the battery (as viewed from the front of the vehicle). Requires removal of battery, and temporary relocation of a fuse/wiring block attached to firewall (no wires need to be disconnected). It's about the size of a phone book. Be sure to follow safe procedures for battery handling. They are hazardous to handle.
On my 1998 gmc safari the ignition module is located next to the ignition coil it is attached to a heat sink lift the inside engine cover off it's on the passenger side top middle of the engine.
on the distributor under the cap with two female connectors in it.
A '96 jimmy does not have a body control module (bcm), it does, however, have an engine control module (ecm) located ontop of the coolant reservoir.
It controls shorting and overload protection for the electronic control module, the "brain" or "computer" located under the right 'kick panel', passengers side.
The 4.3 liter V6 engine in a 2003 GMC Safari has a timing CHAIN
If you're talking about the module that's mounted on the distributer plate then Orielly's has a machine that will check it.
It's in the engine compartment between the engine and the battery.
I am having the same problem with my 2000 GMC Safari. The Service Engine Soon light is on some time. Can any one explain this issue please.
Open the glove box and take the insert out. It should be behind that on the right side.
Under the steering wheel at the very left at the bottom
The distributor is located in a fixed, non-adjustable position. Ignition timing is preset and cannot be adjusted. Ignition timing is controlled by the powertrain control module.
The water pump on a GMC Safari van is located on the front of the engine, below the alternator. It uses a drive belt attached to the crankshaft to circulate water throughout the engine and radiator.