Chevy Silverado
Chevy Blazer S-10
Ford Expedition Eddie Bauer

Where is the fuel pressure regulator located on a 1995 silverado?

272829

Top Answer
User Avatar
Wiki User
Answered
2009-01-13 04:36:00
2009-01-13 04:36:00

It is located under the plastic intake manifold plenum. It is an internal design because it draws it's vacuum from within the plenum. New answer: A 1995 is TBI (THROTTLE BODY INJECTION)

tHE REGULATOR WILL BE FOUND ONTOP OF THE TBI. HOUSING JUST BEHIND THE 2 INJECTORS.

only the vortec engines have it under the upper intake plenuem.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


Yes.. But it would be cheaper to just buy the whole regulator and replace it.


Hi. It is located behind the TBI right where the two fuel lines go in. To replace it you have to remove the carb, and remove the top and lift the whole top off, under there you will see the regulator.


On a 1995 Monte Carlo, the fuel pressure regulator is located on the right side of the engine. The regulator is on the lower right hand side of the cylinder valves.


On 1995 and 1996 models the fuel pressure regulator is integrated into the fuel pump assembly.


What regulator are you refurring to, the fuel pressure regulator... its located on top of the throttle body, its the round thing that's held in place with 3 star screws.


The pressure regulator is located on the pass side of the fuel rail. It has a snap ring on it and all you have to do is take the snap ring off and pull it out. The fuel pressure regulator on a 1995 Eagle Talon non-turbo is an integral part of the fuel rail and is replaced as a unit.


fuel pressure regulator


The engine computer is the voltage regulator.


The voltage regulator is an integral part of the alternator.


Fuel Pressure Regulator is located on the fuel rail.Fuel Pressure Regulator1. Disconnect the negative battery cable.2. Properly relieve the fuel system pressure.3. Remove the air cleaner outlet tube(s).4. Remove any necessary components to access the pressure regulator.5. Disconnect the vacuum hose from the pressure regulator.6. Remove the pressure regulator attaching screws.7. Remove the pressure regulator from the fuel rail.To Install8. Discard the O-rings on the pressure regulator and replace them with new ones.9. Lubricate the O-rings with clean engine oil.10. Install the regulator into the fuel rail and tighten the retaining screws.11. Connect the vacuum hose to the regulator.12. Install any components removed to access the regulator.13. Install the air cleaner outlet tube(s).14. Connect the negative battery cable.




fuel pressure regulator is in the tank, in the pump assembly 1995 it is NOT in the fuel tank. Later models it is ON the fuel tank, but this model has it on the fuel rail. I believe under the intake manifold. It is on the pump, in the tank. There is no regulator under the intake. Some fuel rails have a pressure damper on them, that looks like a regulator.


The pressure regulator is part of the assembly, that round thing on the top of it, where the fuel line connects. YouÊneed to crawl under the truck to take a look, if there is a fuel leak it would smell all the time.


It is on the fuel rail on the return side. The rail meaning where the fuel injectors attach.


The voltage regulator, on your 1995 Ford escort 1.9 liter, is located on top of the alternator. The voltage regulator is attached to the alternator by four retaining screws.



they are in the doors. the regulator is what makes it go up and down and is attached to the window motor.


The engine computer is also the voltage regulatorThe engine computer is also the voltage regulator



What should the fuel pressure be for a 1993 toyota 4 runner?


The crankshaft position sensor on a 1995 Chevrolet Silverado is located on top of the timing case. The part can be purchased at any auto parts store.


I don't know if it's the same on your 1997 Ranger , but on my 1995 Explorer 4.0 L OHV engine , the fuel pressure regulator is on top of the engine about 2 inches to the right of the oil fill cap ( when looking from the front )


The 1995 Chevy Silverado coolant sensor is located on the front of the engine. The coolant sensor will be a few inches above the thermostat housing.


Looking from the front , I believe the fuel pressure regulator on your 4.0 L OHV engine is about 2 inches to the right of your oil fill cap on top of the engine



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.