0
Where is the fuel pressure sensor located on the 2000 GMC Sierra?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the fuel tank pressure sensor located on 2000 ford f150?
fuel pressure sensor is located on the tank
Where is the cam shaft sensor located on a 2000 GMC sierra 1500?
Type your answer here... Where IS Cambshaft sensor in 2000 gmc 1500 and what does it do
Fuel sensor 2000 GMC sierra?
Yes, there is a fuel sensor in a 2000 GMC Sierra.
Where is fuel rail pressure sensor located on 2000 Ford Explorer 4.0 v6?
where is fuel rail pressure sensor on 2000 ford explorer 4.0 located?
Where is the crank shaft sensor on a 2000 GMC sierra located?
in the side of the block, above the started
Where is the fuel tank pressure sensor located on a 2000 Victoria?
it is located on the fuel lines
Where is the IAT sensor located on gmc 2000 sierra 5.3LITER?
The IAT Sensor is attached to the Mass Air Flow Sensor that is attached to your air filter box.
Where is the oil level-pressure sensor located on 2000 Z3 2.3L roadster?
The oil level pressure sensor is located on the front of the engine. The oil pressure sensor is just above where the oil pan bolts to the engine.
Where is the fuel pressure sensor located on a 2000 bravada?
I have a 1997 and it is located on the fuel pump. It plugs into the top of it.
Where is the map sensor located on a 2000 Chevy suburban?
The MAP (Manifold Absolute Pressure) Sensor on a 2000 Chevy Suburban is located on the very top of the motor. It is all the way to the back of the motor. There is nothing behind it.
Oil pressure sensor location on a 2000 VW Beetle?
The oil pressure sensor is usually located next to the oil filter. This means that someone has to get underneath the car and jack it up to reach the sensor.
Where is the Knock sensor in a 2000 GMC Sierra?
they are located under intake manifold The #1 sensor is located in the front of the engine and the #2 sensor is located in the back of the engine. Remember to replace the intake gaskets once you replace the sensor/s. The total time it took me to pull the intake and locate the bad sensor was about 6 hours. Hope this helps
