Mounted on top and inside the fuel tank.
take the 2 screws out of the bottom of the clove box and its right there
The front camber for a Subaru Liberty should be -1.0 degrees. This should be max while being even left to right.
monroe or gabriel I'm a big fan of KYB. If I remember right, that's Subaru's OEM supplier.
I'm about 95% certain that it is.
It is located to the right of the ignition coil pack, on top of the motor. It is the black sensor, right behind the alternator, bolted into the intake manifold.
The fuel filter for a 2000 subaru liberty 2.5 liter can be found inside the fuel tank on the right hand side (driver side) in Australia. It is in the tank with the fuel pump & sender unit (fuel gage). Hope this helps as it took me a while to find it myself.
You have a rod nocking ,you could have a cv joint going out mine took about 1000 miles before it went
Should be on the Pass. side of dash above your right toe if you are sitting in the seat. 3 or 4 screws and it drops out.
Standing at the front of the car: 1)on the left side, near the firewall, just to the left of the center behind the motor, there is a dipstick, this is for your final drive, 2)on the right side, near the firewall, just to the right of center behind the motor, there is a dipstick, this is for your transmission. Both of these are a bit low down, you will have to look, but they are there. Sometimes they will need nudged from down below with a bar to get them free if they haven't moved for a while.
ON FRONT OF RIGHT CYLINDER HEAD, NEAR BREAKOUT TO STARTER MOTOR.
If you have worn rings, the motor is already hurt. If the bearings are as bad as the rings, catastrophic failure is right around the corner.
No, it is the right side view mirror on 2002 subaru legacy