Top Answer
User Avatar
Wiki User
Answered 2007-07-02 03:01:50

u have to drop the fuel tank taking to straps off and remember to detach the filler hose from the tank first and disconnet the battery

User Avatar

Your Answer


Related Questions

Do you need to remove radiator to replace grille on 91 Chevy pickup?

No, you can replace the grill without removing the radiator.

How do you replace a melted tail light wire without removing the dashboard on a 93 Chevy corsica?

the wire is bare how do you replace the wire with out removing the dashboard on a 1993 Chevrolet corsica?

How do you replace fuel pumps on 87 Chevy s10 pickup?

you have a choice of dropping the fuel tank or removing bolts holding the bed to frame and sliding bed back to expose the top of fuel tank. pump is inside of fuel tank

How do you replace a ignition switch on a Chevy 72 pickup?

easiest option is to replace the steering column there all over junkyards with perfect switches in them

How do you replace the water pump on a 1984 Chevy Caprice 305?

One of the easiest but to do it right , get a manual on your car.

How do you replace a Chevy Tahoe knock sensor?

The 4.8, 5.3 and the 6.0 GM engines require removing the intake manifold to replace a knock sensor.

What is the easiest way to replace the heater core in a 1995 Chevy Caprice Classic?

pay me $75.

How do you replace shocks and struts on Chevy Malibu 2003?

It only involves removing the wheel and removing the two strut bolts. Then opening the hood and removing the two nuts and one bolt. Fairly easy.

75 Chevy 250 six can you replace timing gears in chassis if so how?

Try removing radiator for access

Can you replace a Chevy 350 oil pump without removing the motor?

It's kind of a pain to do, but yes it can be done.

How do you replace Cab mount bushings on a Chevy CK 1500?

Whats the easiest way to get broken cab mount bolts out on a 1994 chevy 1500 extended cab

How do you change a starter part on a 2000 Chevy venture?

What is the easiest way to replace the starter motor on a 2000 chev Venture?

Do you pull the trans to replace rear main seal in 1991 Chevy 350?

Yes, That would be the easiest thing 2 do.

How do you repair a head gasket to Chevy prism?

You do not repair a head gasket you replace it with a new gasket which requires removing the head.

Problem removing standard transmission 1994 Chevy something is holding it from dropping out even with a lagre gap between the bell housing?

Try disconnecting the clutch plate from the flywheel.

Need to replace freeze plugs on 1993 Chevy pickup Has 5.7L engine. Plugs are right under the motor mounts. What is the easiest way to replace them?

There is no easy way. You will have to raise the engine up and brace it somehow to keep it from falling and cutting a HAND off while you are removing the motor mounts from the side of the engine.

How do you replace the spark plugs and wires on a 2004 Chevy Astro van?

you can reach them by removing the tires and the wheel well guards [plastic]

How do you replace the thermostat on a 2010 Chevy Impala 3.5?

You can replace the thermostat on your 2010 Chevy Impala 3.5 by removing the water hose and the 3 bolts from the thermostat housing. The thermostat will come right out. Reverse the process to install the new thermostat.

How do you replace the water pump on a 1993 Chevy half ton 5.7L?

Probably one of the easiest but you need direction. Get a manual on your car from DISCOUNTAUTOREPAIRMANUALS.COM

Can you replace a fuel pump through the back seat of an 96 s10 ls chevy blazer?

No. Removing the fuel tank from the vehicle is required.

Have often should you replace a timing belt in a 98 Chevy Prizm?

The Prizm has a timing CHAIN, not belt. The timing chain does not get replaced on a scheduled interval. It should never need to be replaced. The serpentine belt, however, does need to be replaced. Inspect the belt for cracks and glazing, and replace. It is not a difficult DIY job. It is easiest to do it from under the car, after removing the splash pan.

How do you replace rear shocks on a 87 Chevy Celebrity?

I suggest removing the shock mounts at the top (13mm nuts) then the lower (15mm bolt & nut) mount. This can be done without removing the tire/wheel assembly, but I suggest using jacks and removing them.

How do you replace the horn on 1996 Chevy Corvette?

Begin by removing the wiring harness from your 1996 Chevy Corvette horn. Remove the horn retaining bolts. Reverse the process to install the new horn.

How do you replace sun visor on Chevy Malibu?

The sun visor on a Chevy Malibu can be replaced by first removing the retaining screws and sliding it out of the mounting bracket. A new visor can then be put into place and bolted in.

How do you change a Flywheel on a 1999 Chevy Cavalier?

The flywheel typically isn't a service item. If for some reason you did actually have to replace it you would have to do so by dropping the transmission, and all associated bracing, and then removing the bolts securing it to crank. Normally these bolts are secured by triple digit torque figures, so an impact gun is necessary. Removing and installing the flywheel is straight forward, the real issue is actually getting to it.