The Fuel Pump Relay is inside the fuse box under the hood on driver side
Add your answer:
Related Questions
How do you replace a CV joint on a 1992 Chevy pickup?
how do you replace a CV joint on a 1992 Chevy pickup?
Were is the fuel pump relay on a 1992 Toyota pickup 4x4?
were is the relay for 4x4 fuel pump 1992
Where is the fuel pump relay on the 1992 Chevy s 10 pickup?
If it has the 4.3 engine the relay is located under the hood, on the firewall, drivers side, between the master cylinder and the fender.
Can you replace a 1990 Toyota pickup motor with a 1992 Toyota pickup motor?
depends on what motor is in both of them are they both 4cyle or 6cyle
Where is the Location of starter relay for 1992 Nissan pickup?
inside starter.
How do you find the windshield wiper relay if there is one on a 1992 Chevy Lumina?
Yes, there is a windshield wiper relay on a 1992 Chevy Lumina. The windshield wiper relay is located in the underhood fuse panel.
Where is the 1992 Chevy 1500 pickup cam shaft sensor located?
1992 Chevy trucks did not have a CAM SENSOR. They had a distributor.
Where is the fuel injector relay located on 1992 Toyota pickup?
Where id the fuel injector relay located on a 1992 toyota camery 4 cylender
Where is the location of the horn relay in a 1994 Toyota pickup?
I have a 1992 Toyota pickup, Had a HARD time finding the horn relay myself. The horn relay on my 1992 Pickup is located on the drivers side, to the right (or towards the front of the truck) of the small fuse block that has an access panel door on the kick panel, you have to remove the kick panel to see the relay, in my case it was just unplugged, plugged it back in and horn now works. The relay has printing on it and it says "HORN RELAY" Good luck! Laterz, Len P :) I would like to find the Fuel Pump relay on my 1992 Toyota pickup.
How do you adjust the throttle position sensor on a 1992 Chevy pickup?
You cant
Does the ecu run the fuel pump on a 1992 s10 pickup?
NO. The fuel pump relay on outer firewall by W. wiper motor, under plastic sheild/cover - drivers side.
Does a 1992 Chevy pickup have a carbon fiber drive shaft?
Not from the factory, it doesn't.
What size is front ring gear in 1992 Chevy pickup?
The size of the front ring gear in a 1992 Chevy pickup is 7.5 inches. The 7.5-inch ring gear needs a 26 spline axle shaft.
Will a 1978 Chevy 350 motor bolt to a 1992 Chevy turbo 350 transmission?
No turbo 350's in 1992.
What is the size of 1992 Chevy 1500 pickup front grill?
Please be more specific.
2.8 Chevy 1992 s10 pickup firing order diagram?
Click the link.
If a 1957 Chevy pickup truck body be placed on a 1992 Chevy s-10 blazer?
Not without fabrication.
What is the towing capacity for a 1992 half ton Chevy S10 pickup truck?
how much can a cheve s10 1992 pull ?
Will a 5 speed transmission out of a 1992 Chevy pickup bolt into a 1976 Chevy c10 motor?
Sure will if they are both small blocks. Never change the bell housing bolt pattern. Im asuming your Chevy c10 probably had a straight six, a three fifty, or a 305. It will be same as a 1992 350, 305, or a 4.3l. Just make sure the flywheel is right for the motor, depending if it is internatly balanced or externaly.
Can a 1995 Chevy Suburban 5.7 liter motor fit in 1992 Chevy Suburban?
Yes.
Will a 1992 Chevy K1500 cab fit a 1995 Chevy K1500 pickup?
YES, All the cabs are the same from 1988 to 1999
Where is the ecm located in a 1992 Chevy s10 pickup?
Inside the dashboard, to the right of the glove box.
What is the torque spec for the axle nut on a 1992 Chevy Silverado Pickup?
173 FT. LBS.
What is the 5 bolt hole pattern for a 1992 Chevy pickup?
4 x 43/4
What size rims came on a 1992 Chevy k1500 pickup truck?
16 inch rims
