The reset button is inside the trunk on the driver's side. You will need to pull off some of the carpeting (Don't worry, it has velcro). You will see the module there on the side. If you want to relieve fuel pressure (like when you replace the fuel filter), unplug the electrical connector from the inertia switch. Then start the engine and run it until it stops. Once you're done working simply plug the connector back into the inertia switch. REMEMBER TO ALWAYS DISCONNECT THE NEGATIVE BATTERY CABLE BEFORE WORKING ON THE CAR. Hope this helps.
No reset button. Look for a fuse.
No, a 1994 Jeep does not have a reset button.
there is no-such thing as "hood reset" but the hood pop hook is located on the lower driver side labeled HOOD
It does not have a reset switch.
Dodge does not use inertia/reset switches.
GM cars do not have inertia/reset switches.
It is inside of the gas tank.
no
NO
Can you put a 1994 thunderbird motor in a 1996 thunderbird?
reset button for what? if you want to reset everything there isn't a button but you can dissconnect the negative battery cable and wait about ten minutes that should clear everything
GM vehicles do not use inertia/reset switches.