answersLogoWhite

0

In a 2000 Mitsubishi Mirage, the ignition fuse is typically located in the fuse box under the dashboard on the driver's side. To access it, you may need to remove the cover of the fuse box. Check the diagram on the inside of the cover to identify the specific fuse related to the ignition system. If you're experiencing ignition issues, ensure the fuse is intact and replace it if necessary.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

Why does ignition fuse blow when key is turned to acc?

Sounds like a short.


Fuse blowing when you turn ignition on 240z?

If the fuse blows when you turn the ignition on in a Datsun 240Z, it typically indicates a short circuit or an electrical fault in the ignition system or related wiring. Common culprits include damaged wiring, faulty ignition switch, or malfunctioning components like the ignition coil or starter. Inspect the wiring harness for frayed or exposed wires, and test the ignition components for proper functionality. Replacing the blown fuse alone won’t solve the problem; it's crucial to identify and rectify the underlying issue to prevent future fuse failures.


What does IGN mean in fuse box?

Oh, dude, IGN in a fuse box stands for "ignition." It's like the key to starting your car, but for your electrical system. So, if you blow that fuse, you might be stuck with a dead engine... or worse, no radio!


What is Black button on 2000 dodge caravan on fuse box under dash Van won't start unless it is pressed and held WHILE turning key so it seems like an ignition interrupt?

That sounds like a part of an aftermarket alarm system.


99 Concord engine won't turn off have to pull fuse under the hood replaced ignition switch already now what Can turn key to off position and radio ac etc turns off but not the engine?

sounds like you have a broken ignition wire between ignition switch and fuse box


Where is the fuse for Mitsubishi mirage 98 model?

I own a 1996 Mirage and my fuses are right under the steering wheel, like right under but kinda near the door. u pretty much have to lay on the floor to see them, if u have a users manual it will tell u what fuses are what.


What is a EGI fuse?

An EGI (Electronic Gas Ignition) fuse is a safety device used in electronic ignition systems, commonly found in gas appliances like furnaces and water heaters. It serves to protect the ignition circuit by interrupting the electrical flow in case of a fault or overload, preventing potential damage to the ignition system or other components. If the fuse blows, it typically indicates a malfunction that needs to be addressed before the system can operate safely again.


Is there a deluxe class mirage from transformers 3?

NO, people who say mirage is a real dotm deluxe figure and do reviews about mirage are just getting a car from a company like hot wheels and re-painting the car red to look like mirage.


Why would i Loose dash lights whene ignition is turned 87 300zx?

It's most definitely a fuse in the fuse box on the drivers side next to the pedals. Pretty sure it's like a 15 or something fuse.


What causes Engine 1 fuse to blow on 2000 Chevy Express vans?

The Engine 1 fuse on a 2000 Chevy Express van can blow due to several reasons, including short circuits in the wiring, faulty components like the ignition system or fuel injectors, or excessive load from accessories. Additionally, issues with the engine control module (ECM) or other connected electronics can also lead to fuse failure. It's important to conduct a thorough inspection of the electrical system to identify and resolve the underlying cause of the blown fuse.


Why does your ignition e fuse keep blowing on your Chevy Trailblazer?

Sounds like a short in the wires somewhere. you will need a diagram & have to trace them.


What could cause the 30 amp fuse in the fuse box on the left side of engine compartment to blow everytime you turn the key to the second click of the ignition switch and then it blows Thanks Charlie?

you need to find out what that fuse protects and look for a grounding condition in the wiring or device. Somewhere there is a 12volt wire touching ground or a component has burned out is is doing the same. sounds like a short in the ignition swith test or replace ignition switch