Flasher Location
Answer If it is like my 98 Grand Marquis, it is incorporated within the hazard flasher switch on top of the steering column. Before spending money to get it repaired, try squirting some WD 40 around the switch and push it down and let it pop up several times and wiggle it around. It worked for me when my flashers, turn signals, and brake lights stop working. Apparently, over the years gunk finds it way in there, be it dirt, liquids, etc. Pressing the flasher switch can sometimes initiate the problem. I don't believe there is a plug-in "flasher" you can replace as you may remember in older vehicles.
== ==
location is above fuse panel.you have to take out fuse panel to access top of panel where flasher is located
The turn signal flasher on a 2001 Chevy Cavalier is located inside a panel close to the gas pedal. The turn signal flasher is very easy to change and they can be purchased from many auto parts shops.
Change the flasher first.
How do you change the flasher on a Chevy S-10?
Behind the AC control panel on the dash... Go figure!!!
The signal flasher is located under the hood on the passenger side of the washer fluid filter. If you need to change this piece, make sure you shut the vehicle off and let it cool first.
The flasher relay on a 1996 Jeep Grand Cherokee 318 by unplugging the old flasher and plugging in the new one. The flasher relay is located under the dash on the driver's side.
The signal flasher is located behind the fuse panel in the glovebox. I find it easier to remove the ashtray to access it. The hazard flasher is behind the glovebox on the right hand side and it's a pain to get to.
The hazard flasher unit is located under the LH side of the instrument panel between the junction block and the brake pedal.
Under dash, driver's side. The flasher may be located someplace else under the dash.
It is connected to the back of your Hazard Flasher. I just had to change mine. About $65.00 to $70.00. Couple of clips at the bottom of front panel then it just pops out.