The heater control valve on a 1992 Pontiac Grand Prix is typically located in the engine compartment, near the firewall on the passenger side. It is connected to the heater hoses that run between the engine and the heater core. To access it, you may need to remove some components or hoses for better visibility. Always refer to a repair manual for specific guidance and safety precautions.
Where is the the heater control valve??
The heater control valve on your Pontiac Grand Prix is located behind the kick plate, on the passenger side of the passenger compartment. The heater control valve is near the heater core box.
where is the heater control valve
location of heater control valve on 2005 mercury marguis ?
Where is idle air control valve located on 2003 Pontiac Grand Prix GT, 3.8 liter 6 cylinder?
It does not have a heater control valve.It does not have a heater control valve.
The heater control valve on a 1995 Pontiac Firebird is typically located on the firewall, near the passenger side of the engine compartment. It is connected to the heater hoses that run from the engine to the heater core. To access it, you may need to remove some components or insulation for better visibility. Always ensure the engine is cool before attempting to locate or work on the valve.
To replace the heater control valve in a 2006 Pontiac Montana, first, disconnect the negative battery terminal to ensure safety. Drain the coolant from the radiator, then locate the heater control valve, which is typically found near the firewall. Remove the hoses connected to the valve, unscrew it from its mounting, and install the new valve in the reverse order. Finally, reconnect the hoses, refill the coolant, and check for leaks before reconnecting the battery.
behind you glove box
Probably in the 1997 Pontiac trans-am heater core valve holder. If not, you probably lost it. Both the valve, and your mind.
The heater control valve on a 1997 Pontiac Trans Am is typically located in the engine compartment, mounted on or near the firewall. It is connected to the heater hoses that run to the heater core. To access it, you may need to remove any obstructions such as the air intake or other components. Always consult a repair manual for specific details related to your vehicle.
The heater control valve is used to shut off hot coolant from entering the core when the heater is in the off position. A heater control valve can be actuated by either a vacuum line or a cable from the vacuum heater control valve to the heater core. This hose should be warm; if not the heater control valve is stuck and needs to be replaced