0
If you mean the release, it is on the very left (under where your light swith knob panel is) part way under the dash. It lays flush and when you slide your hand forward you will feel a space towards the front and you pull it down and toward you. If you look under the dash you can see it. Kind of square approximately 3" square.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you open the hood in a 2001 Pontiac Grand Am?
Opening the hood on a 2001 Pontiac Grand Am is very easy to do. The hood is opened by pulling on the hood release latch inside the car on the drivers side. After the latch is pulled the hood will release. The hood is then opened by pulling the second release under the hood.
How do you put the interior hood latch on 05 G6?
How do you put the interior hood latch back on a 2005 Pontiac G6 mine fell off.
Will hood from 1987 Pontiac Fiero fit on 1984 Pontiac Fiero?
Assuming you are speaking of the front hood, and not the rear engine cover, yes, the 1987 hood will fit the 1984 Notchback. All front hoods are the same, 1984 through 1988. There is a vast parts interchangeability including exterior, interior, electrical, chassis, engine, and transmission, with the 84 through 87 models. Some changes were made in 1988, for instance larger brake rotors, better suspension, etc. so not as many parts are interchangeable with the 1988 and the other years.
Where is the hood latch to open hood 1988 Volvo?
where is any hood latch? usually located near the drivers left foot, under the dash board.....
Where can you find a wiring diagram for a 1987 Pontiac Fiero?
on a sticker located on the underside of the hood on the right side
Does 1986 Pontiac Fiero hood raise from the front or the back?
The front hood raises from the rear or windshield end, the rear hood raises from the rear or bumper end
Fiero Front Hood Release?
The fiero front hood release cable has an extra cable tucked inside the release lever housing. If they're both broke then you'll have to use a crowbar and lightly pry up on the hood but be extremely carefull not to break the fiberglass hood. Take a long flat tipped screw driver and remove the foam padding around the latch then take a 10mm stubby wrench and remove the 2 bolts holding the latch to the car then just raise the hood and trip the latch. Remove the old cable and install a new one.
How do you repair the hood latch of a 97 Pontiac Trans Sport?
go to pisk a part and get a used one. If their is one there.
How do you open the hood on a 1989 Pontiac Bonneville car when the hood latch cable is broken?
if you can at least pop the hud a little bit you can rich your hand under the hun and pull on the latch that should let you open the hud.
How do you change the hood latch cable on a 1990 Pontiac Firebird when you cannot find the answers in your repair manual?
It depends on what is wrong with the cable. When you pull the hood release within the car, is the latch not popping? If you can get the hood up at all, then you should look at the actual latch system where the cable runs, there is a metal clip that holds the cable to the latch. Have another person pull the interior latch release and watch the cable.
Where is the hood release on a 1986 Pontiac Fiero?
It is located left side of the instr. panel on the bottom... flush mount... do a headstand and look under the dash and there it is!!!
How do you replace a hood latch on a 1995 F150?
To replace a hood latch on a 1995 F-150, the old hood latch will have to be cut out with a blow torch. The new hood latch will have to be welded in place. Securing with bolts after welding will make the hood latch stronger than that of the original.
