0
its more of a matter of just going and getting one from a salvage yard or going to autozone or your local auto parts store and buying a horn, not a difficult procedure
Wiki User
∙ 17y ago
Wiki User
∙ 14y agoyou push in the blinker bar
Add your answer:
Earn +20 pts
How do you fix the rear door locks on a 1994 Mercury Topaz that will not unlock manually?
Most likely rust has settled in. The best way is to remove the door panel and spray all the parts with either a rust spray, or Wd40. If you cannot open the door to get the panels off, then roll down the window, and use an oil can and squirt oil all over the lock parts, and work the lock at the same time. Might take some time, and put a piece of carton under the door to catch all the oil. Good luck.
If the timing is off in a '92 Mercury Topaz how do you fix it?
the timing is usually set by adjusting the distributor and using a timing light on the number one cylinder and pointing the light at the harmonic balancer on the bottom of the engine crankshaft pulley,the timing mark on thr balancer should be marked on the correct degree for example 10 degrees before top dead center. as the distributor is turned the timing on the light will adjust to the balancer . to get the correct timing look under your hood for a sticker that has timing and sparkplug gap specs.
Your 1994 mercury topaz 2.3L 4-cylinder eng. has high idle all the time how can you adjust.Does it have an idler air control motor or an idle control valve going bad would appreciate some help Jerry H?
I had the exact same problem, with the same model car. You need to replace the idol air controller valve. I bought one at the local repair shop for 80$. It should not take more than a few minutes to fix. It is located on the backside of the intake manifold. It is a black box near the center,and in the back. It has an electical connection that clips on the side of the box. There will be two bolts that will require an 8mm wrench or socket to take off. This is important....the replacement part(if new from the part store) will have to be put on the Opposite of the one you take off. In other words, on the topaz model, you will be putting the new part on upside down.
Why does a '94 Mercury Topaz die when run in hot weather but will start again ok if shut down for about a half hour?
Have the module in the dist checked out. I had the exact same problem for 2 years. And every one had a different reason. Its a bad fuel pump, i promise. Replace the fuel pump and throw on a new fuel filter and it will run great. just make sure you dont buy the cheapest one. I did that and it broke a year later. ive had a new one in for about 4 years now and no more problem. replacing the pump means emptying your gas tank enough to drop the gas tank and remove the top of the tank the pump is right there its a pain in the butt but relatively cheap if you do it yourself. around $60.00 dollars.Good luck I have a 93 Topaz that had the same issue, and it was an easy fix - the solenoid needed to be replaced. If the problem is the solenoid, the problem may get worse so that the car won't even start when it's cooled down.
How do you fix overheating engine 1993 mercury topaz?
Depends on why its overheating. IF the Radiator fan is not kicking on, then there are several things you can check. One is that the AC system is working properly. Unfortunately, Ford tied in the AC system to the cars cooling system (overheating). And without the AC System working properly you might have to wire a toggle switch directly to the fan, with a fuse link on one side, to be able to manually turn on the fan when the car reaches temperature. IF the AC unit is working properly there are 2 sensors. One is on top of the thermostat housing, and actually is in the housing. The other is in the engine block right next to the thermostat housing. IF either of these is not working properly, then the fan unit will not come on. If that is not the problem, you may have a blockage somewhere, and need a serious cleaning of the radiator and/or engine block.
1993 Mercury Topaz sucks air how to fix?
yes
How do you fix the gas door for a mercury topaz- 1998?
Are you really sure it is a '98 ?
90 topaz mercury to shut off when it gets hot and starts when cool?
90" topaz mercury is getting hot and shut off and the starts when it cool off.? what is the cause of this and how do i fix it?
What should you do to fix the horn on your 1997 Mercury Mountaineer?
replace it.
Where do you look for the problem and how do you fix it if the speedometer on a 1993 Mercury Topaz is not working?
Most likely speedometer cable
How do you fix the horn on a 1989 Chevy Cavalier?
Make sure the 1989 Chevrolet Cavalier horn fuse is in working condition. Make sure the positive and ground wires on the horn are tight and free of corrosion.
How do you fix the radio that works --but with no lighted display--on a 1993 Mercury Topaz?
If it is working what needs to be fixed? Assume, the lack of display. Not sure but I think the radio has two separate fuses, one for the radio one for it's display, check the fuses I have had similar problem but not sure if it was with my Topaz
How do you fix the horn on a 1988 camaro?
To fix the horn on a 1988 Camaro, check the horn fuse first. Then check the horn relay, wiring, horn, and switch to find the problem.
How do you fix the horn on a 1989 Chevy S-10 truck?
Well first you have to find out what is wrong with the horn and than fix the problem, could be loose wires, horn could be bad, the wires could have rusted. your best bet is to cut the wires, unbolt the horn and hook up a brand new one and then put some wire nuts on there and if that dont work than your wiring is bad.
How do you fix the horn on a 1997 Acura Integra?
The horn on a 1997 Acura Integra uses one wire. When a horn stops working it is usually due to a bad fuse. To fix the horn replace the fuse labeled HORN.
How dop you fix a horn that does not work on a 2007 spectra?
Check the horn fuse, and connector on the horn
Where is the horn on a 1991 Mercury Tracer?
It is located on the front crossmember near the bottom of the radiator. It has 2 10mm screws attaching it to the chassis, if you clean the bolts abd where the horn meets the frame you will fix the ground circuit and the horn may work again with out a new part. ( at least it always has on my car)
