I had the exact same problem, with the same model car. You need to replace the idol air controller valve. I bought one at the local repair shop for 80$. It should not take more than a few minutes to fix. It is located on the backside of the intake manifold. It is a black box near the center,and in the back. It has an electical connection that clips on the side of the box. There will be two bolts that will require an 8mm wrench or socket to take off. This is important....the replacement part(if new from the part store) will have to be put on the Opposite of the one you take off. In other words, on the topaz model, you will be putting the new part on upside down.
no but it does have a manual hot /cold lever control box which is adjusted via vacume hoses attached to the heater control unit on the dash
The lines are from Mercury because Mercury has lines which are from Mercury which has lines on it because it is Mercury. The lines are Mercury lines because it is Mercury, and since it is Mercury, it has lines from Mercury because it is Mercury totally. So, Mercury has lines from Mercury since being Mercury from Mercury lines. WHAT!
Yes but you can't put a larger then 125w bulb in.
chloride:- mercury (I) chloride mercury(II) chloride oxygen:- mercury oxide iodine:-mercury iodide flourine:- mercury(II) fluoridemercury(IV) fluoride bromide:- mercury bromidesulphur:- mercury sulphate mercury sulphidenitrogen and carbon :- mercury cyanide
I suspect that your Control Unit itself has gone bad. That's what happened to me. A new control unit will cost between $400 and $500. I got one from a Junk Dealer for $100. It's been working for 3 years now. The control is real easy to change out. Hope this helps.
It's your switchbox, I just did this on my 75hp 4cylinder.
Hey, I am looking for the exact same thing. I hope someone answers soon...
Where is ignition control module on a 2001 mercury sable
location of heater control valve on 2005 mercury marguis ?
To replace the 1996 V6 Mercury Sable climate control and take out the old control, you will need to remove the covering below the steering wheel and dashboard. Then, access the climate control in the instrument panel and remove the old control.
"This is simple. The circulation number for the Manhattan Mercury is 10,125 daily and 11,450 on Sunday. It is very popular and many individuals enjoy and appreciate their service."
The cruise control module of a 1993 Mercury Villager is located under the passenger side of the dashboard.
PCM stands for Powertrain Control Module on a Mercury Sable
What is a gem module for 1999 mercury sable? And what does it control?
where is the heater control valve
the elictronic control sinsor at on a 93 mercury villager
The cruise control computer module is located on the passenger's side of the engine compartment on a 1993 Mercury Villager.