Hi, the new tigra 05 onwards has 2 seats - 1 driver and 1 front passenger. Hope this helps ! : )
Set idle speed to proper r.p.m, by adjusting the IDLE SPEED SCREW. Turn the IDLE MIXTURE SCREW or the AIR SCREW to for correct procedure, achieve highest speed and best response. The IDLE MIXTURE SCREW (FCR) controls fuel delivery to the idle port and the SCREW is located on the engine side of the carburetor slide. Turning the IDLE MIXTURE SCREW out will make idle and off-idle richer. Turning IDLE MIXTURE SCREW (CR, PWK, PJ, PE) controls the amount of air to the IDLE and SLOW CIRCUIT. This SCREW is located on the air cleaner side of the throttle slide and turning the SCREW out will lean the mixture and turning the SCREW in (clockwise) will richen the mixture.
Idle is computer controlled, no adjustment screw.Idle is computer controlled, no adjustment screw.
There is an idle screw on the side of the carb its the one you can turn by hand if you have to use a screw driver its probably not the idle screw. turn it CW to increase and ccw to decrease.
A model E converter does not have an idle screw. Your idle adjustment would be on your Mixer, equivalent of the carburetor.
twist the top of the choke, there is no idle screw on the 1999 yz250
Idle is computer controlled, there is no adjustment screw.
The idle on a Toro push mower can be adjusted by turning the screw located on the carburetor. Turn the screw to the right to gain idle speed and turn the screw to the left to diminish idle speed.
At the base of the carburetor are 2 screws. One adjusts the idle speed and the other adjusts the idle mixture. Screw the idle mixture in until the engine starts missing then screw it out 1 turn. Then, adjust the idle speed screw to about 850 RPM.
For non fuel injected models, on the side of the carburetor there is an idle screw. Turning the screw slightly will raise the idle on your Chevy truck.
micra idle adjustmentThe idle screw is under the auto choke unit, Philips screw head.
There is no idle screw. The idle air control valve controls the idle and can be set on different settings. You should consult a Ford dealer or mechanic for proper settings.