I suggest you get a manual on your car and acquaint yourself with it. They are available for $9 from DISCOUNTAUTOREPAIRMANUALS.COMAnswer
its in the distributor cap. you can get a cap to accomidate an external coil from MSDAnswer
In the distributor. Remove cap and it is the large black(in most cases) box with four screws and two wires.
ANSWER the ignition coils (4 to be exact ) are on the top of each spark plug, They are called coilovers and don't need to be changed unless a misfire is indicated often and then you can change one at a time. Hope tis helps you
The ignition coil is inside the ignition distributor.
It is inside the distributor.
Its inside the distributor.
The ignition coil is inside the distributor....
its inside the distributor cap
A '94 Civic CX uses a distributor based ignition system.
follow spark plug wires back to other end & that is your coil
ignition coil! mine did the same
The ignition coil on a 1998 Honda Civic LX is located under the distributor cap. The distributor is on the passenger side of the motor and has wires running from it to each spark plug. it is usually plastic.
It's inside the distributor.....On the flat side....
Inside the distributor just under the distributor cap.
Check Gas pump and relays
Inside the distributor cap. 3 screwes hold it down. Remove them, pull off the dizzy cap and you will see the coil.
It could be your ignition coil, which is located inside of your distributor cap. Supposedly, the ignition coils in our civics are poor design and lack providing enough power. I have a 95 civic LX, I gave my car a much needed tune-up. My car ran for 5 minutes and just died.The coil just went out. The coil itself is about 80. They also make external ignition coils and modified distributor caps to by pass the internal coil for about 100
a little 8 mill screw on bottom of rotor into dist shaft
You can test the ignition coil on a car by using a multimeter. A bad ignition coil can be the cause of a car not starting.
can you interchange 00 civic parts with 04 civic parts
No. The coil provides the spark and the module tells the coil when to spark.
if's it's a 1.5 or 1.6 ltr. it's in side the distributer cap.
The coil is located in the distributor internally. If you take the distributor cap off and unscrew the rotor it should become visible. You may have to move a dust cover, but it is in there.
Remove the wiring harness from your 1999 Mercury Grand Marquis ignition coil. Remove the ignition coil retaining screws. Reverse the process to install your new ignition coil.
The 1998 Toyota ignition coil is located on the firewall, in the engine compartment. The ignition coil can be found on the passenger side of the firewall.
It is in the distributor, pull off the cap and it is held in with 2 screws and has 2 wires coming off of it. firstname.lastname@example.org
V6 Engines * Disconnect the negative battery cable * Disconnect the electrical connector from the ignition coil * Disconnect the spark plug wires from the ignition coil * Remove the ignition coil mounting bolts and remove the coil from the valve cover V8 Engines * Disconnect the negative battery cable * Disconnect the electrical connector from the ignition coil if youre going to remove more then one ignition coil mark each electrical connector with its corresponding coil to prevent mix-ups during reassembly * Remove the ignition coil hold-down bolt * Grasp the ignition coil firmly and pull it straight up
REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.