On V-6's Inside the distributor, remove the distributor cap,remove the rotor,
it has 7 terminals to it; [3 on one side closest to passenger side and the coil, and 4 on the other side closest the driver side] . usually black in color, but there are some white ones. this is below the pole piece or the hall effect sensor.
Two small 3/32 head bolts mount it to inside of the distributor. It is hard to remove the wire connections.
Where is the control module located on the 1983 Chevy blazer
The ignition module is located in the distributor, under the distributor cap.
where is the ignition control module loacted on a 1997 chevy cavalier
The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.
under the coil pack or on the distrbutor
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
Depending on what type engine you have, the ignition module may be an integral part of the distributor cap.
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
69 :3
its located on driver side head on top of block little black module with plugwire running out of it
The ignition control module is located under the electronic ignition control module cover. On a 1997 2.4L cavalier, it will have the words 2.4L twin cam stamped on it. It is on the top of the engine and is held in place with four bolts. This cover must be removed to get to the spark plugs.
The ignition control module is located directly beneath the coil packs. These can be found at the rear of the engine, on the top center. Just look for where all the spark plug wires connect, those are the coil packs, and they are bolted to the ignition control module. It has three electrical connectors, two on the driver's side and one on the passenger's side.