The ECM (engine control module ) is located on the center of the firewall just above the motor. It's the thing that has a lot of wires going to it.
Ignition power control is located on the intake driver side next to intake motor control looks like small module black color. This is for 95 diamante with 3.0 SOHC engine.
The wiper control module is located inside the wiper motor assembly.
AnswerSince 1996, engine ignition control has been handled by the Powertrain Control Module (PCM).The PCM has direct control over the ignition coils / coilpack (or coil-on-plug on some engines) - so the need for a 'distributor' has gone away.Coilpacks cost about $75Sidebar: without a distributor, the engine timing is also totally handled by the PCM.See "Related Questions" below for information about Ignition Control Modules on 1986-1995 Taurus/Sables.On a 1996 Ford Taurus the ignition control module is part of the drivetrain control module. To change the ignition control module you have to change out the computer. It is located behind the motor on the passenger side of the engine compartment. Look for a screw holding in a wiring plug with a dozen or so wires. The drivetrain control module has a couple of nuts holding it in place and looks like a cdrom when removed. Good luck. John
The windshield wiper control module is usually in the fuse box located in the engine compartment of most automobiles. Sometimes the windshield wiper control module is located on the firewall next to the windshield wiper motor.
the ignition module can be in 1 of 2 places for that year and depending on the size of motor. it will either be on the side of the distributor or on the driver side fender. if it's on the distributor, it will be gray and have a plug in it. if it's on the fender, it will be a electrical box and have 2 plugs on it.
It is located under the dash near the blower motor.
In the front of the motor by the transmission dipstick. This is where your spark plugs from the engine go.
windshield wiper motor. Or it could be the wiper module. If under the hood, its the motor. The module is usually located inside the car.
It could be that the Ignition Control Module is faulty. There are known to go bad during the motor being hot, but once cooled down the engine will start. This is located on the front of the motor, underneath the the coil packs. You have to take the coil packs off, and unplug the ICM (Ignition Contol Module), and it will fall off from there.
It is located on the transfer case this is the motor that shifts your four wheel drive
On the firewall to the right (when facing the firewall) of the blower motor.
The 2000 Chevrolet Corvette blower motor control module can be found behind the passenger side dashboard. You will need to remove the dashboard in order to access the module.