answersLogoWhite

0


Best Answer

Inside of distriutor cap under the rotor (pick up stator). Very seldom fail. About 90 us dollars at local parts house.

User Avatar

Wiki User

โˆ™ 2006-12-01 01:43:50
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the ignition control module on a 96 probe 20L with an external coil?
Write your answer...
Submit
Related questions

Where is the dura spark ignition module located on a 1991 Ford probe?

The 1991 Ford Probe spark ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


Where is the location of ignition control module for 1996 Probe 2.0?

it should be located under the battery on the inside of the front fender.


Where is the location of ignition control module for 1994 ford probe 2.0?

most of the time it is located next to the fuel filter up against the strut wall, this is of course you have an external coil, should be 2 staggered "star" headed bolts holding it on.


Where can you buy a ignition control module in the distibutor type for your 1993 Probe 4-cylinder automatic?

You can't. it's integrated. Do a HEI-mod instead, cheaper and more effective. Do a search on google for Hei-mod +ford probe.


Where is the ignition module on a 1993 Ford Probe 4 cylinder?

In the dist. Takeit to Auto zone and have them check it out.


Where is the ignition control module for 1995 Probe 2.0?

two types of ignition systems. On some models, the module is mounted on the outside of the distributor body, just under where the cap mounts. It is a rectangular, flat box with a large electrical connector. The second type of ignition is controlled by the ecm, or main computer which is located under the center of the dash, behind the console.


After changing the ignition module on your probe gt still have no spark?

Why start with the module? The coil is is a good place to start. Make sure of course you have voltage at the coil, if not trace it back.


Why do the Distributor unit fails on 1995 Ford Probe GT?

There is a small ignition module (relay) that is built into the distributor that is notorious for burning up.....


1990 ford probe 3.0 runs then cuts off after about 5 minutes?

If the car is cutting out after 5 minutes then most likely an electrical component is heating up, then failing. Some suspects include the ignition control module or ignition system parts/coil and pickup, if applicable.


What is the solution for a 1976 ford 302 that loses spark after about fifteen minutes?

check ignition module with the engine craking and a automotive tst light atached to th battery gound probe the ignition coil on both sides one shold light the light the other should be a blinking grond if not replace the ignition module


Where is the Engine control module on 97 Ford Probe gt?

The ECM is located inside your center console behind the controls.


Where is the control module located in 93 Ford Probe?

The Control module (I am assuming you are referring to the ECM) is located forward of the center consol and below the dash. The center consol and radio a/c control trim faceplate must be removed to gain access to it. Stan


Why does Ford Probe ignition stays on even when key is not in ignition?

Defective ignition switch or tumbler assembly.


Is the power train control module of a 1993 probe gt 2.5 v-6 compatible with 1995 ford probe 2.0 4-cylinder?

no it is not. simply because you can't swap a 6cylinder computer with a 4 cylinder


Where is the ignition coil in a 1995 ford probe gt?

Built into the distributor.


Who has a Space Probe Mission Module?

F-14D-SuperTomcat - As of August 6 2012


How do you set the ignition timing on a ford probe gt 95 with an mx engine?

To set the ignition timing on a Ford Probe GT 95 with an MX engine, remove the two 12 mm head bolts holding the distributor in place. Then rotate the distributor to set the ignition timing.


Where is the air bag module for a 1993 ford probe?

i dont know but have one they are small and i have mosts part in places you would not think love my red probe/great car


Will aliens probe you deeply?

Not if you know the 'control word' that will help you control their minds and actions.


Why would my 93 probe gt fuel cutout light come on and die bypassed inertia switch changed fuel pump and filter now just no spark to plugs even after replacing dist cap and rotor?

my 1993 probe gt done the same thing with the no spark at the plugs the ignition module was bad i replace the whole distributor and it runs great


How do you remove speed limiter 0n 91 probe?

you cant easily as it is internal to the master engine computer module


What does a moon landing probe do?

The lunar module lands on the moon and it helps as a launch pad for the spacecraft to return to earth.


How do you set ignition timing on a 1995 Ford Probe?

there are two dots on the distributor they have to be lined up on tdc


Is the mariner 10 probe still in space?

No, On March 24th, 1975 the probe ran out of attitude control gas and the mission was terminated.


What is Ignition timing 1990 Ford Probe 2.2?

motorcraft.com shows for the 1990 Ford Probe 2.2 L ( 133 cubic inch ) 4 cylinder : ignition timing : 6 degrees BTDC , and --------------------------------------------------------------------------------------------------------- 9 degrees BTDC - manual transmission - with turbo - with self test connector grounded