0
Where is the ignition switch on a 2003 Ford Expedition located?
Wiki User
∙ 15y ago
The Ignition Switch is where you put your key to start the vehicle. Removal & Installation 1. Disconnect the negative battery cable. 2. Remove the steering column shroud and lower the steering column. 3. Detach the ignition switch electrical hardness connector. 4. Remove 2 nuts retaining the ignition switch to the steering column housing. 5. Lift the ignition switch upward to disengage the actuator rod from the switch and remove the switch. To install: > When installing the ignition switch, both the locking mechanism at the top of the column and the switch itself must be in the LOCK position for correct adjustment. To hold the mechanical parts of the column in the LOCK position, move the shift lever into PARK (with automatic transmissions) or REVERSE (with manual transmissions), turn the key to the LOCK position, and remove the key. New replacement switches, when received, are pinned in the LOCK position by a metal shipping pin inserted in a locking hole on the side of the switch. 6. Engage the actuator rod in the ignition switch. 7. Place the ignition switch on the steering column housing and loosely install 2 retaining nuts. 8. Move the switch up or down along the column to locate the mid-position of the actuator rod lash, then tighten the retaining nuts to 47-64 inch. Lbs. (5-7 Nm). 9. Raise the steering column into position at instrument panel. Install steering column shroud. 10. Connect the negative battery cable. 11. Remove the locking pin, connect the battery cable, and verified that the engine will only crank in PARK and NEUTRAL. Also check to make certain the start circuit cannot be actuated in the DRIVE and REVERSE positions.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is cruise control deactivation switch located on 2003 ford expedition?
Located in the brake pedal assembly
Were is inersia on 2003 expedition?
On a 2003 Ford Expedition : The fuel pump inertia switch ( shut off switch ) is located in the cargo area , on the drivers side , near the liftgate , behind the access panels
Show you how to replace ignition coils for a ford Expedition 2003?
98 expedition
Where is the 2003 expedition fuel shut off location?
On a 2003 Ford Expedition : The fuel pump shut off switch ( inertia switch ) is located in the cargo area , on the drivers side , near the liftgate , behind ( 2 ) access panels
How to Remove ignition switch from Nissan?
how to change a ignition switch on a nissan altima 2003
Where is the fuel pump fuse located on a 2003 expedition?
where is the gas pump fuse located in a 2003 expedition
How do you replace the fog light located on a 2003 Ford Expedition?
How do you replace the fog light located on a 2003 Ford Expedition?
Where is coil pack located on 2003 Ford Expedition?
On a 2003 Ford Expedition : It has the Coil On Plug ( C.O.P. ) ignition system with ( 8 ) individual coils firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of vehicle
Where is the fuel safety switch located on the 2003 Ford Expedition Eddie Bauer?
my 2003 Ford Expedition seem to have a fuel or relay malfunction. I can get the truck to crank if the doors are locked and unlocked several times, but it still will not start at all.
How do you unlock the ignition switch on a 2003 dodge neon?
How do i unlock my ignition switch on 2003 dodge neon sometime it does it some times it doesn't but now it wouldn't unlock
Where is the killer switch found on a 2003 Ford Expedition?
If you mean the fuel pump inertia switch ( shut off switch ) in a 2003 Ford Expedition it is in the cargo area , on the drivers side , near the liftgate , behind the access panels
Where is the fuel pump inertia switch located on 2003 ford expedition?
In the left rear of the cargo area , by the liftgate , behind 2 removable access panels
