hi, i could'nt find the inertia switch on my Ford Probe 1994 for ages. Eventually I found it just above the wheel arch on passenger side in boot but you have to remove the plastic covering. Not easy to locate. Hope this helps.
If you crimp the three wires running to the inertia switch together and remove the switch, it will close the circuit thus bypassing the swich. I have a 1993 Ford Probe SE that this has been done to and as of yet it has no direct or indirect complications from doing this. If you crimp the three wires running to the inertia switch together and remove the switch, it will close the circuit thus bypassing the swich. I have a 1993 Ford Probe SE that this has been done to and as of yet it has no direct or indirect complications from doing this.
On the passenger side, under a cover in front of the door, on the side of footwell
in the trunk. under the carpet, in the leftside quarterpanel
No it does not. That is a Ford thing.
On a 1993 Ford Mustang : Open the trunk lid or the hatch Between the rear tail lights you will see an oval shaped rubber plug The inertia switch is behind the rubber plug
Passenger side lower kick panel
diagram of starter in a 1993 ford probe
If you are talking about the inertia switch, it is in the hatch on the driver's side under the floor mat behind the wheel well.
I'm not a mechanic / technician but I BELIEVE the fuel pump inertia switch on a 1993 Ford Ranger is in the front passenger footwell , under the front edge of the carpet , mounted on the toe board just to the right of the transmission hump
Ford vehicles have this switch, no GM vehicle use an inertia switch.
If you mean "inertia switch", it doesn't have one. That's a Ford thing.
you push the red reset button on the inertia switch