I'mworking on a 1987 Ranger. The questions asked are; 2 or 4 wd, super cab or reg., rear tank or center tank. Mine is a 2whd,reg. cab, with a center tank, and today I found out I have two (2)fuel pnmps. One inthe tank and one on the frame rail just below the drivers side floor board. I have not yet been able to do a fuel pressure test but I have confirmed that both pumps do run. Neither pump seems to be to difficult to change. The one in the tank will be time consumming but do able. My present consuren is if I do a pressure check and it is low how do I deterrmine which is not up to par? Good luck with your truck and wish me the same.
The inline fuel filter is located on the left frame rail.
how do you change a fuel filter and were is it located on a 2000 xlt ford ranger
special inline wrench gm ford Chrysler OTC tool # 6509
what is the engine size? That is missing information. Are you asking about the ignition system? If you are, I can give you the exact information from a the Haynes Ford Ranger & Bronco II 1983 thru 1992 2WD and 4WD models with a gasoline engine Repair Manual if you give me this tiny bit of information
two inline
where is the fuel filter located on 96 ford ranger supercab
the slave cylander is located in the transmission on the 2002 Ford Ranger. Better see a mechanic to do the job.
INLINE WITH THE AIR INTAKE NEAR THE AIR FILTER.
No
The Ford Ranger 2.3 is an inline 4 cylinder engine and the firing order is 1, 3, 4, 2.
how to i change a clutch in a 1993 ford ranger
1987-1988 Rangers did not use Canister Filters, just the inline filters. The canister is still there in those years but theres nothing in it.