It should be located on the air intake hose before the Mass Air Flow Sensor. Hope this helps.RR Of The Engine Compartment
The EGR valve is located on the side of the intake on the 2000 Pontiac Grand Am. It is close to the intake manifold.
On the intake manifold near the thermostat housing. It will be two wires a yellow and one black wire.
how to replace a distributor gasket on a 2000 Pontiac grand am 3.4l
It's located right on the intake tube.
It is on the intake manifold near the thermostat housing.
The thermostat is located at the driver side of the engine, under the air intake piping. All the intake stuff must be removed to get to the housing which has two bolts holding it in place. The lower bolt, located under the exhaust pipe, is a Bear to get at! Replace with an OEM part, as SOME of the generic parts won't allow you to get the housing back on without removing the exhaust.
It's located on the intake manifold itself.
the intake sensor located with the air flow sensor.
The knock sensor for a Pontiac G6 is located on the side of the engine. It is mounted at the exhaust manifold.
The intake air temperature sensor on a 2005 Subaru WRX is part of the mass air flow sensor. It is located in the air intake duct.
under intake on backside of motor.
The Intake Air Tempature sensor is located on the air intake duct about mid way down the duct.
The thermostat is located near the intake on a 1999 Pontiac Grand Am GT. The thermostat can be located by following the upper radiator hose directly to the thermostat.
Usually the Throttle Position Sensor is located by the intake manifold, usually at the end of your air intake.
The intake air temperature sensor is located just after the top of the intercooler. It will have color coded wires coming from it.
The IAT (Intake Air Temperature) Sensor is a Two (2) Wire sensor located close to the intake.
on the intake manifold on the driverside.
disconnect the temperature sensor located under air intake , on thermostat bell housing that should automatically turn on the fans
It is in the rubber snoot that comes off the TB
Located in the air intake plenum.
were is tempeature located
It is located on the intake manifold next to the fuel rail.
You do not, you have to replace it.