0
The knock sensor is in the engine V under the intake manifolds and coolant crossover pipe. As it requires considerable disassembly and an expensive new gasket set to reach it, I suggest you make very sure there is something wrong with it first. You will have to remove the upper and lower intake manifolds and coolant crossover pipe assembly to reach it. Just because you are receiving a trouble code for it does not mean there is anything wrong with it. This sensor shares a circuit with other components that often will set a "ghost" trouble code.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where to find knock sensor in a 1997 Chevy Lumina?
The knock sensor, in your 1997 Chevrolet Lumina, can be found on the front of the engine. The knock sensor is near the top of the engine.
Where is the knock sensor on a 1997 thaoe?
location of knock sensor in 1997 cheverolet Tahoe SUV 305 or 350 engine
How do you remove the knock sensor from a 1997 Mercury Villager?
It's under the intake manifold. The whole assembly needs to be removed, it's a complex process.
Where is the 1997 Saturn SL knock sensor located and how do you replace it?
The 1997 Saturn knock?æsensor is located on the back of the engine. The knock sensor can be removed by removing the wiring harness and the retaining bolts.
Does a 1997 Ford Taurus sho have a knock sensor?
Yes , one of Ford's websites lists a knock sensor for the 3.4 liter SHO engine in a 1997 Ford Taurus
Where is the knock sensor on a 1997 expedition?
it is in where the timing chain is. mike
Does 1997 ford ranger 2.3 have a knock sensor?
Yes, there is a knock sensor on the 2.3L. It is located on the rear driver's side of the cylinder head.
Where is the knock sensor on a 1997 Mercury Villager?
The knock sensor is under the intake manifold.Replacement of it requires an experienced mechanic.But first, do a diagnostic check before condemning it. This requires checking for voltage fluctuations with a voltmeter hooked up to the knock sensor sub-harness electrical connector. The sensor signal uses a white wire usually- the terminal is located to the immediate right from the upper left corner terminal on the 1997 model. You tap the intake manifold with a hammer and observe voltage fluctuations (this tap simulates knock from the engine). If no voltage fluctuations are observed, the sensor is bad. But if you do observe fluctuation, your knock problem is elsewhere.
Where is the knoock sensor on a 1997 Nissan Maxima?
The knock sensor is located below the intake manifold
What sensor on a 1997 mercury grand marquie make it not start?
cam sensor
How many knock sensors on a 1997 Cadillac eldorado and where are they located?
One Sensor.... Removal Procedure 1. Remove the intake manifold. 2. Disconnect the knock sensor electrical connector. 3. Remove the knock sensor. Installation Procedure 1. Install the knock sensor. Tighten the knock sensor to 19 Nm (14 lb ft). 2. Connect the knock sensor electrical connector. 3. Reinstall the intake manifold.
1997 Nissan maxima where does a knock sensor go?
the Knock sensor is located behind the Harmonic balancer pulley. on the bottom sidethe sensor is $95.00 remove the lock down screw unplug and replace
