Car Computers and Sensors
Chevy Silverado

Where is the knock sensor in a 1991 Chevy Silverado?

192021

Top Answer
User Avatar
Wiki User
Answered
2010-05-18 13:01:39
2010-05-18 13:01:39

It is screewed into the passenger side of the engine, just in front of the starter.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


All the speakers in a 1991 Chevy Silverado should be 4x6 if they are stock.


Location of knock sensor 1991 GM sierra 350 2500?


There is no "knock sensor" on a 4.0L engine


There is no knock sensor on a 94 4L jeep engine. In 1991 when they changed to the 4L HO motor, they removed the knock sensor from the system.


It is located right above the starter for a 5.7l V8, not sure for the 4.3 or 5.0, probably the same place


Make SURE the engine is COLD. Then unscrew the old sensor and install the new one. Antifreeze will leak out of the engine so be quit when replacing it.


The function of the knock sensor ob a sensor on a 1991 4.3 s10 is to provide the computer the position of the crank shaft to give it the right information to get correct timing. That would be the crank position sensor. The knock sensor monitors the engine for spark knock (ping) so the ECM (Engine Control Module) can retard the timing to eliminate it.


1991 probably doesn't have a crank sensor, it probably has a reference in the distributor.


where the map sensor on 98 blazer?


Generally, a stock silverado will have four speakers; two in the dashboard and two behind the seat.



Was built for R12, can be converted to R134a.



YES, It will bolt right up with NO modifying.


how to release serpentine belt tensioner on 1991 C1500 Chevy Silverado?


What engine? V8? 18436572 for chevy 1991 silverado v8 350 diagram


That year did not have a MAF sensor / Mass air flow sensor.


Removing a 1991 Chevrolet Silverado door panel is pretty simple. All you will need to do is to remove the screws holding the door panel in place.


The tire jack on a 1991 Chevy Silverado is used by placing it at the anchor points just behind the front tires and just in front of the rear tires. It is raised or lowered using the provided detachable handle.


the knock sensor is on the rear of the motor next to fire wall. you need to pull the engine struts and tilt the motor forward and look with a mirror on the passenger side lower 1\2 of motor, it has one wire goin to it. brass colored. under exhaust manifold.



Haynes makes a manual with the wiring schematic for the O2 sensor on a 1991 Chevy Blazer S10. The manual can be found at most book stores.


The knock sensor on Nissan 300ZX non-turbo from 1990 thru 1996 is located below the lower intake manifold on the rear of the engine block. To replace the knock sensor the upper and lower intake manifolds need to be removed. It is always best to replace the knock sensor with a new one considering its major dissasembly.



why 1991 Chevy silverado misses out while under power



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.