0
It is located right above the starter for a 5.7l V8, not sure for the 4.3 or 5.0, probably the same place
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is the speed sensor on a 1991 Chevy K1500?
it's located in the rear of the transfer case
Where is the knock sensor in a 1991 Chevy Silverado?
It is screewed into the passenger side of the engine, just in front of the starter.
Location of knock sensor 1991 GMC sierra?
Location of knock sensor 1991 GM sierra 350 2500?
Where is the knock sensor on a 4x4 1991 Ford Explorer?
There is no "knock sensor" on a 4.0L engine
Where is the fuel pump on a 1991 Chevy k1500 located?
In the fuel tank
Where is the water temperature sensor for the gauge cluster located on a 1991 Chevy K1500 305 engine?
There is'nt one on the guage cluster but there is on the motor up by the thermostat housing
Is the Chevy 5.7L v8 ovh 16v a 350ci?
Yes, yes it is! I know i have a 1991 Chevy K1500 with one of them in it.
Will 1992 Chevy 5.7 liter fit a 1991 Chevy silverado K1500?
YES, It will bolt right up with NO modifying.
How do you change a knock sensor on 1991 Chevy 350?
Make SURE the engine is COLD. Then unscrew the old sensor and install the new one. Antifreeze will leak out of the engine so be quit when replacing it.
What is the function of a knock sensor on a 1991 4.3 s10?
The function of the knock sensor ob a sensor on a 1991 4.3 s10 is to provide the computer the position of the crank shaft to give it the right information to get correct timing. That would be the crank position sensor. The knock sensor monitors the engine for spark knock (ping) so the ECM (Engine Control Module) can retard the timing to eliminate it.
What type of refrigerant goes into a 1991 Chevy K1500?
R-12 from factory Should be converted to R134
Is there another coolant sensor that would affect the operation of the dashboard temperature gage on a 1991 Chevy K1500 305 the temp sensor next to the thermostat housing has already been replaced?
There is a sensor located between exhaust manifold #1 and #3 (drivers side). This sensor controls the temp gage in a cars interior.
