Make SURE the engine is COLD. Then unscrew the old sensor and install the new one. Antifreeze will leak out of the engine so be quit when replacing it.
It is screewed into the passenger side of the engine, just in front of the starter.
Location of knock sensor 1991 GM sierra 350 2500?
There is no "knock sensor" on a 4.0L engine
It is located right above the starter for a 5.7l V8, not sure for the 4.3 or 5.0, probably the same place
The function of the knock sensor ob a sensor on a 1991 4.3 s10 is to provide the computer the position of the crank shaft to give it the right information to get correct timing. That would be the crank position sensor. The knock sensor monitors the engine for spark knock (ping) so the ECM (Engine Control Module) can retard the timing to eliminate it.
There is no knock sensor on a 94 4L jeep engine. In 1991 when they changed to the 4L HO motor, they removed the knock sensor from the system.
1991 probably doesn't have a crank sensor, it probably has a reference in the distributor.
where the map sensor on 98 blazer?
code 15 coolant temp sensor low temp indicated change cts sensor or test with multi meter
No.
the knock sensor is on the rear of the motor next to fire wall. you need to pull the engine struts and tilt the motor forward and look with a mirror on the passenger side lower 1\2 of motor, it has one wire goin to it. brass colored. under exhaust manifold.
That year did not have a MAF sensor / Mass air flow sensor.