The Knock sensor is on the back side of the engine underneath the intake manifold. If you do not have the intake off you will need to get under the car and above the oil filter to the left you will see two sensors. One is close to the oil filter and the other is up to the left more by the intake. The one that is close to the intake is it. It is usually blue or black and it has a wire clip coming out of it with wires going to the wire harness. This is a very expensive item running about $150.00 on average so make sure that it is bad before you step up to replace it. Most do it your selfers would pass on this just because of the cost and the fact that to test this sensor you would need a scan tool to diagnose the function of this sensor. Some shops or auto parts stores will scan your vehicle for free and if it comes up with the engine code that the knock sensor has problems check basics first. Is it plugged in? Is there power going to it? Are the wires in good condition? If the answer is yes to all of these questions and your check engine light is coming on and the only code is there is a problem with the knock sensor then it is probably something to get replaced.
In between the bottom of the intake manifold and the oil filter. It is really hard to do it by yourself with little to no mechanical skill.
Where is the LAF sensor located on a 92 honda civic?
There can be many causes for a Honda Civic to stall. Some of them include a bad fuel pump, a bad alternator, a bad distributor, a clogged air filter or idle air valve. Buy a Honda Civic Service manual for more information. http://www.HondaCivicRepairs.com do it myself Honda civic repair
The coolant sensor is also the temperature sensor, it can be found on the head under the distributor for 1.5 liter Civic motors prior to 1992.
How do you repair a key lock on 2005 Honda Civic car? Thanks Nina Scott
i would like a wiring diagram for a Honda civic o2 sensor
How do you repair 1999 Honda Civic Horn?
where is the tdc in my 98 civic ex sedan
Idle Air Temperature sensor.
IT is a Intake Air Temperature sensor
the one before the catalytic converter, easily accessible from under the hood, right on the exhaust manifold
The 2006 Honda Civic coolant temperature sensor is located on the front of the engine. The coolant temperature sensor will be in the vicinity of the thermostat housing.
The 1995 Honda Civic speed sensor is located on the front passenger wheel. The speed sensor will be found on the inside of the brake rotor.
m18x1.5 is the threading for Honda civic/del sols, and probably most other o2 sensor bungs
Hi Every one Can you help meWhere Is the heater 02 sensor and heater circut fault sensor 1 for 1999 Honda Civic?
See for yourself in this pic for a 95 Honda Civic
A wiring diagram for the oxygen sensor on the 1992 Civic can be found at your local auto parts store. Haynes sells a manual for the 1992 Civic with a diagram included in it.
where the oil pressure sensor located on 1997 Honda Civic EX 1.6L
In the Dist.
The intake air temperature sensor on a 2007 Honda Civic is found inside the intake system. The sensor is placed near the air filter box.
The speed sensor is found on the transmission of the 1992 Honda Civic. To replace the unit locate the mounting bolts and remove them. Unplug the wiring clip and pull the sensor off.
This is a major repair that should only be attempted by a professional. This is not a DIY repair for a novice.
The knock sensor on the 2002 Civic is on the engine block. It is located on the intake manifold just below the engine oil pressure switch.
The crankshaft position sensor can be found on the bottom of the engine in a 2000 Honda Civic EX. It is next to the crankshaft itself.