0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the sencer located next to the oil filter on a 1986 305 Chevy motor?
That would be the oil sending unit.
What can make a 2000 Mercury Sable 3.0 dohc run lean?
the o2 sencer, temp. sencer, or the air temp sencer can. the o2 sencer, temp. sencer, or the air temp sencer can.
When was David Sencer born?
David Sencer was born in 1924.
When did David Sencer die?
David Sencer died in 2011.
What does tha crank sencer do?
What will be the sign when the crank sencer is not working?
How do you install the crankshaft position sensor on a 1987 Buick Grand National?
rotate the engine until you have the gape on the interupter ring over the crank sencer. remove the crank sencer assembley that bolts to the block with the sencer attached. ( do not take the 5/16 bolt loose that holds the sencer.(unplug the wires to the sencer first. once yu have remover the sencer assembley from the block you can tell how to set up the new sencer. mark the sencer with a knife or paint pen so you can see how to set up new sencer. Now you are readty to remove the 5/16 bolt. back the bolt out and remove the sencer for the bracket. pay attention where you marked the old sencer. Mark the new sencer in the same location and place it back in the bracket,( Be sure to alighn the sencer exactly as the old on. Then tighten the 5/16 bolt back..DO NOT over tighten this bolt. now reinstall assenbley back onto the block. Be sure not to break the window of the new sencer as you reinstall. it will be a tight fit but it will go. Take a flywheel tool and turn engine BY HAND to make sure you have properly set up your sencer. As long as it does not hit it will be good. if it does hit, back off the 5/16 bolt and move the sencer until it does not make contact with tha interupter ring on the crank shaft. plug your wires back into the sencer. start engine an have fun.. Hope this help.
Where is the 1999 Acura Integra cooling fan sencer?
1999 fan sencer for acura integra
Why does the oil light flicker at idle on your 2001 Chrysler Sebring with a 2.7 engine?
Low oil, low oil pressure, failed oil pressure sensor.Low oil, low oil pressure, failed oil pressure sensor.
Why does the engine oil light come on when car is at operating temperature?
Low oil level, low oil pressure, failed oil press sending unit.Low oil level, low oil pressure, failed oil press sending unit.
What causes the low oil level light to come on?
Low of oil or low oil pressure. If the engine is not low of oil then the oil sending unit may be bad or the oil filter may be clogged. The oil pump may also be weak.
Where can you get the cheapest co2 sencer?
Try Amazon.com
Where is the heat sencer located on the engine?
on the top
