0
Where is the low pressure port to recharge the ac on a 1991 Volvo 740 turbo?
Wiki User
∙ 13y ago
Next to AC accumulator/drier, which is in the engine bay in front of the firewall. When looking from the front, it is on the left side of the car, an aluminum cylinder approx. 4 inches in diameter.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Does a 1991 Volvo 940 have air bags?
no i have a Volvo 1991 se turbo.
1991 Volvo 740 turbo hard start when cold?
My 1991 740 volvo turbo doesnt start specially during the morning.Is it comes with a cold start valve?
How do you replace an ignition switch in a 1991 Volvo SE Turbo Wagon?
replace ign sw on 1991 volvo 240
How do you fix a 1991 940 turbo 4 cylinder Volvo to stop runing when travling down the freeway?
How to fix a 1991 940 turbo 4 cylinder Volvo to stop running when traveling down the freeway
Where can you locate the radio code for your Volvo 1991 740s turbo?
You can locate the radio code, for your 1991 Volvo, by consulting your owners manual. The owners manual should have all of the vehicle codes.
How much oil do you use for an oil change in a 1991 Volvo 740 Turbo SE?
4 quarts in the non turbo so should be around the same
What motor comes in a 1991 Volvo 740 turbo?
BF230FT 2.3L 4 Cyl w/ Mitsubishi or garret turbocharger.
Why would there be white smoke coming from the hood of a 1991 Volvo 940 turbo?
check the hose from the turbo to the air mass meter on the bottom of it may be burst very common repair or replace.
What is the recommended refrigerant pressure for a 1991 Volvo 240 that has been retrofitted for R134a?
60-90Psig
Where is the low pressure port on a 1991 VW Jetta so that one can recharge the air conditioning?
The 1991 VW Jetta low pressure port can be found on the air conditioning compressor. There are two ports, the low pressure port will be labeled as such.
Where is the horn located on a Volvo 1991 740 Turbo?
under the bumper on the left front volvodoctor It's on your steering wheel brainiac.... j/k
What would cause no brake pedal after power booster and master cylinder have been replaced on 1991 940 Volvo turbo. Vacuum line is not working properly?
was system properly bled? ensure there are no leaks and if there is absolutly no brake pressure it is not a vacuum problem, it's something else.
