Want this question answered?
On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.
The camshaft sensor on the 99 Olds Intrigue is located on the engine block. It is under the starter, which has to be removed to locate the camshaft sensor.
there is none. the speed sensor is in the tranny
On the passenger side of the engine, toward the front of the side. Near the alternator.
The ETC sensor on the 2002 Olds 3.5 engine is located at the right rear of engine, below the throttle body at the head not the block.
35mm
I have a 98 olds intrigue...the camshaft position sensor is located around the middle polley on the left side of the engine. It has one screw. It's fairly easy to install.
$300 with labor
You have to drop the starter on the front bottom driver side of the engine... next to the transmission. The crank sensor is about in the middle of the block. One bolt holds it in.
Yes it has four.Yes it has four.
I have Olds Intrigue 2000 3.5L. Needed to replace faulty crankshaft sensor.3.5L engine has two of them. If engine is hard to start cold or hot and engine light is OK.Very common problem for this engine in Aurora 3.5 and Intrigue 3.5 is crankshaft position sensor. Which is located above and behind starter. Starter must be removed first.------------------------------------------------------------------------------------------------------------AnswerLower right hand side of the engine just above the oil pan. Theres a single bolt that holds it in.
Under the glove box.