0
In the exhaust system before the catalytic converter.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the fuse panel located under the hood in a 92 Chevy Corsica?
passengers side top (relays)
Why did your 92 Chevy Corsica suddenly stall and never start again?
Could be your crank sensor. These are very common to fail on these cars.
Where is temp sensor located on 92 Chevy 3500 with 454?
The 1992 Chevy 3500 temperature sensor is located on the front of the engine. The temperature sensor will be in the vicinity of the thermostat housing.
Where is cooling fan sensor on 92 Chevy Corsica?
FIRE WALL SIDE OF ENGINE, A LITTLE UNDER THE EGR VALVE. T HEMPLE
Where is the speed sensor located on a 92 Chevy K1500?
The 1992 Chevy K 1500 speed sensor is located on the back of the transmission. The speed sensor will be in the upper right-hand corner of the transmission.
Where is the camshaft position sensor in a 92 Chevy s10 4.3 l located?
Inside the distributor.
Where is the speed sensor located in a 92 Chevy Cavalier?
the speed sensor is located next to the passenger front side tire. probably about a foot away from the tire
Where is the LAF sensor located on a 92 Honda Civic?
Where is the LAF sensor located on a 92 honda civic?
How do you install a serpentine belt on a 92 Chevy Corsica?
Put the new serpentine belt on to your 1992 Chevy Corsica pulleys. Push the tensioner pulley to the left to tighten the serpentine belt.
Where is the PVC valve on a '92 Chevy Corsica?
IF IT'S A 3.1 ENGINE IT'S LOCATED ON THE BACK, FACING THE FIREWAL, VALVE COVER. SLIGHTLY UNDER THE INTAKE PLENIUM.
92 Chevy Corsica with no cruise control is it possible to install one?
im sure it is, and i doubt its worth it.
How do you replace the turn signal switch located on a 1992 Chevy Corsica?
Since the 92 Chevy Corsica is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.
