assuming its a truck right???
there should be at least 2 if not 4
on your exhaust,one for each side of the exhaust 2 before the cats. and two after
It is screewed into the side of the engine over by the starter.
what part of motor is the knock sensor located on 1996 Chevy S-10 4 cyl. passenger side of engine block
it is in the distributor
It is back by the distributor and screews into the engine just about were the distributor goes into the engine.
Bottom right of the water pump. Dead center of the engine in the front.
The Camshaft Position (CMP) sensor is located on the passenger side of the engine and is accessible after removing the right front tire-2.2L engine.
That is the only electronic device that's in the distributor under the rotor button.
should be located on the side of transmission
The knock sensor for a 1996 200sx is located on the passenger side of the engine. It is located under the intake manifold.
In the distributor.
The Manifold Absolute Pressure (MAP) sensor is located on the firewall side of the upper intake manifold plenum
Its in the distributer.