answersLogoWhite
Chevy S-10
GMC Jimmy
Toyota RAV4
Chevy Blazer S-10

Where is the oil drain bolt on a 1996 Chevy S-10?

141516

Top Answer
User Avatar
Wiki User
2007-02-13 22:47:10
2007-02-13 22:47:10

The drain plug is on the bottom of the oil pan if you look under the truck it is at about the middle of the vehicle, and about as far back as the back of the front tires. The bolt faces towards the passenger side. It should take a 15mm socket or wrench.

1

Related Questions

User Avatar

The wrench size should be 15mm.

User Avatar

The original engine oil drain plug wrench size would be 15mm.

User Avatar

It is a tight fit, but you can get to them from the top if you remove the distributor first.

User Avatar

Unbolt it, pretty easy just one bolt in the middle of the arm...

User Avatar

Chevy s10 blazer lug pattern is 5x4.75 with 6" back spacing

User Avatar

AnswerThe engine oil drain plug is located at the lowest point on the engine oil pan.

User Avatar

1985 Chevy s10 RWD on 14' factory wheels bolt pattern is 5x4.75 (5x4 3/4) .

User Avatar

bolt pattern for these model smaller chevy's is 5x4.75

User Avatar

How do you replace the front drivers seat on a 1996 Chevy S10 pick up truck

User Avatar

The fuse box diagram for a 1996 Chevy S10 is located on the back of the panel cover. It identifies the location of each fuse and its use.

User Avatar

whats the firing order for a 1996 Chevy s10 ls 4.3 letter engine

User Avatar

The S10 pickup has the 5x4.75 bolt pattern.

User Avatar

how to drai torque converter on 1999 chevy blazer

User Avatar

To drain the oil on a 1991 Chevy S10 Blazer, located the oil pan drain plug. Use a wrench to remove the plug and the oil will flow into the receptacle you have provided.

User Avatar

Replace the drain plug gasket and don't over tighten it.

User Avatar

its on the left hand side of the radiator but not very easy to get to My apology, it is a 1996 S10 Chevy Blazer instead of a 1999 Chevy Blazer. I need to see a picture or more detail of where the drain plug is located on the left side of the radiator. I have searched and searched and cannot find anything to drain with. Thanks, Linel

User Avatar

Do you mean a drain for the freon? If so, there is no drain. It needs to be evacuated and stored in a holding tank by law.

User Avatar

1994 to 2004 second generation S10's should bolt in.

User Avatar

The started on a 1996 Chevy S10 4 cylinder is located under the battery and to the right. With the right tools and time it is not hard to replace.Ê

User Avatar

There is no cable, it is hydraulic operated.

User Avatar

check for a vacuum leak.

User Avatar

It is built into the headlight switch.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.