You can only access it from underneath the car. First remove the front steel bash plate on the left hand side. To remove the oil filter element you will need a Toyota tool to unscrew the plastic lid on the underside, so best buy the tool when you buy the oil filter.
After resetting the fuel light on a 200 series do you have to drain the filter or do anything else?
remove the black plug from sensor on top of the filter with ignition in the off position,start the engine,replace the plug and the light will be off. I tried this but the light is still on!
will a 200 series bullbar fit on a 100 series
The filter is on the bulk head passenger side (roughly) just underneath the windscreen
You have to remove the whole centre area of the dash. Follow the instructions here: http://www.australianimages.com.au/project200/dash-pull-apart.php
Passenger side, under bash plate alongside chassis.
Depends on the mile per gallon your diesel gets. Divide the MPG your vehicle gets into 200 and you will have your answer.
The Cm-200 Has no oil filter.
About 374.8 pounds.
200
I have one that is a 175 Hydro and it uses an AM101054 which is very common for Kawasaki engines. I got one at the local lawn equipment shop for $10.
Rover 20T2N 2.0Ltr Diesel engine Cam cover torques are listed as 12 Nm. No tightening sequence is listed .