0
Where gravity can get the oil out; usually under the deck, covered in grass clippings and rust. Probably a square bolt head. Either break out the 12 point socket set, a big channel lock, or suction the old oil out through the dipstick hole with a Mityvac.
Some mowers have oil filters, some don't. Change it if you got it. Also a good time to change, or at least clean, the sparkplug. 2$ part that can make a world of difference
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the drain plug on a yardman lawnmower?
Many Yardman Lawnmower models do not have a drain plug. If no drain plug is found the oil has to be removed by the oil fill tube.
How do you change oil on lawnmower?
Depending on what lawnmower you have just simply take the spark plug out and tilt lawnmoer
How do you change the oil in a lawnmower?
With the engine off and the plug wire off the spark plug, you will need to remove the drain plug on the bottom of the engine. Drain the oil, install the plug and fill with 30w oil.
Where is the oil plug for the craftsman 6.5 lawnmower?
Your owner's manual should explain that.
How do you change oil in a Craftsman 625 series lawnmower?
The oil drain plug for the Craftsman 625 series lawnmower is located on the bottom of the mower, just above the blade. Tip the mower back. The plug is round and threaded with a square head. Using the square head of a ratchet extension, twist the plug counterclockwise and remove. The oil will start draining. Once it has drained, replace the plug and tighten clockwise until snug. Replace with new lawnmower oil or SAE-30 weight oil.
Where is the drain plug on a Honda lawnmower?
There is none you suck the oil out with a pump provided by the dealer.
How do you change oil on craftsman 6.0 lawnmower?
youtube - push mower oil change.... oil plug under mower deck
What can be used to seal the oil drain plug in a lawnmower?
A bit of teflon tape can work wonders.
How do you change the oil in a craftsman 6.75hp lawnmower?
Depending on the model of the Craftsman lawnmower, there is either an oil plug underneath the deck of the mower which needs removed to drain the oil or the lawnmower needs tipped on it's side to allow the oil to drain out through the oil cap area. Once oil has drained you will want to refill the oil until the dipstick registers "full".
My mum has accidentally put a whole bottle of lawnmower engine oil in the lawnmower and now it won't start what do i do?
Drain the oil and catch it in a clean container if you intend on reusing the same oil . Then replace the plug and place the correct amount of oil in the motor.
Does mixing gas and oil together ruin your lawn mower?
If your lawnmower is a 2 stroke mixing oil in the gas is what it needs to run right. If your lawnmower is a 4 stroke mixing oil in the gas fouls the plug and makes it not run.
How do you change oil on a lawnmower?
Refer to user manual if you have one. Most engines have a small plug at the bottom of the oil receptacle which allows the old oil to be drained.
