0
Where is the oil pressure gage on the 1989 Pontiac Bonneville?
Wiki User
∙ 17y ago
the guage should be located in your dash next to the speedometer, but if you are reffering to the pressure sending unit it is located on passenger side, behind the powersteering pull best accessed for wheel well or from below the car
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you find gage pressure?
Gage pressure is the difference between atmospheric pressure and absolute pressure. If you fill your tire to 35 psi as read on a tire gage, this is the gage pressure. The absolute pressure inside the tire is the pressure of the atmosphere (14.7 psi normally at sea level) plus the gage pressure.
When was Gage Daye born?
Gage Daye was born in 1989.
How do you install an oil pressure gage?
after market oil pressure gage instalation on a vw bug
When was Gage Knox born?
Gage Knox was born on July 12, 1989.
What would cause a 2000 Pontiac Bonneville not to have power after replacing the starter and reconnecting the battery?
check your starter wires there should be wires going to 2 different places on the starter, 1 large gage wire to the copper terminal and 1 smaller to activate the solenoid
Your fuelbatterycoolant and oil pressure gauge don't work on your 1988 ford f-150?
The fuel gages, the battery gage, the oil pressure gage, and the coolant gage are on the upper instrument cluster?
If the absolute pressure of gas is 550.280 kPa it Gage pressure is?
The gauge pressure would be 448.955kPa.
What is absolute pressure of 110 kpa gage at standard condition?
You are supposed to add that pressure to the atmospheric pressure.
What is absolute pressure?
Absolute pressure is simply the addition of the observed gage pressure plus the value of the local atmospheric pressure.
What does absolute pressure include that gauge pressure does not?
abosulute pressure includes the atmospheric pressure while gage pressure gives the pressure above atmospheric pressure
How do you check the oil pressure?
You need to remove the oil sending unit and install a oil pressure gage in it's place then start engine and read gage. Iwould tell you were the sending unit is but you did not say what you are working on. You need to remove the oil sending unit and install a oil pressure gage in it's place then start engine and read gage. Iwould tell you were the sending unit is but you did not say what you are working on. You need to remove the oil sending unit and install a oil pressure gage in it's place then start engine and read gage. Iwould tell you were the sending unit is but you did not say what you are working on.
If the absolute pressure of gas is?
Absolute pressure is simply the addition of the observed gage pressure plus the value of the local atmospheric pressure.
