0
Where is the oil pressure sending unit located on the 1990 corsica?
Wiki User
∙ 16y ago
If the car has a 3.1 or a 2.8, the sensor is located right next to the oil filter, to the right about 1 inch.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is the oil sending pressure switch located for a Lexus LS400 1990?
behind the oil filter
How do you replace the water pump on a 1990 Chevy Corsica 2.2L?
Where is the Water Pump located and how do you replace it on a 1990 Chevy Corsica?
How do you recharge ac on 1990 Corsica?
The AC system can be recharged in a 1990 Chevy Corsica by connecting a refrigerant tank to the low pressure inlet. Refrigerant is then added until the correct pressure is reached.
Where is the oil pressure sending unit on 1990 Honda accord?
It is located directly above the oil filter.
Where is the trunk release for a 1990 Chevy Corsica located?
in the glovebox.
Where is the TCC solenoid located on a 1990 Chevy Corsica 3.1 engine transmission?
The 1990 Chevrolet Corsica TCC transmission solenoid is located on the top of the transmission. The solenoid will be near the back of the transmission.
Where is the Oil Pressure Sending Unit located on a 1990 Ford F-150 with a 302 motor?
The oil pressure sending unit on a 302 ford is located on the block of the engine. It screws into the block and the sending unit goes on the end. The oil pressure sending unit on a 302 Ford is slightly above and to the left of the oil filter. I find it is easier to replace with the oil filter out.
Where is the Oil Pressure Sending Unit located on a 1990 4.3 Chevy S-10 Blazer?
The oil pressure switch is directly behind the carburator. Between the distributor and the carb.
Where is the computer located in a 1990 Chevy Corsica?
under the kick panel passenger side
How big is the gas tank on a 1990 Chevy Corsica?
The gas tank on a 1990 Chevy Corsica is 15.6 gallons. A 1990 Chevy Corsica takes unleaded gas not premium.
How take out a wheel drive in a 1990 Chevy Corsica?
Too my knowledge there is no such animal. Describe the part and what it does, where it is located.
How do you remove the oil sending unit on a 1990 Chevy Corsica 3.1 ltr?
unhook the wire, screw the whole sensor out then thread the new one in and hook up the wire
